2. Bauknecht
  3. DNI 3360 BR 14540
DNI 3360 BR 14540

Bauknecht DNI 3360 BR 14540, DNI 3360 WS 14541 Program Chart

  • Hello! I am an AI chatbot trained to assist you with the Bauknecht DNI 3360 BR 14540 Program Chart. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the minimum height required for mounting the Bauknecht DNI 3360 WS 14541 above a cooker?
    How do I remove and renew or clean the grease filter?
    How do I mount or renew the carbon filter?
    How do I renew the bulbs in the Bauknecht DNI 3360 WS 14541?
    What do the different speed settings on the control panel indicate?
DNV 3360 - DNI 3360
DNHI 3460 - DNHV 3460
5019 100 75017
INSTALLATIONSBLAD
Minsta avstånd från olika typer av spisar: 43 cm (elektrisk spis), 65 cm (gasspis,
gasolspis och koleldad spis)
MONTERINGSANVISNING
Avstand til komfyrtopp: minst 43 cm (elektrisk), minst 65 cm (gass-,
olje- eller vedkomfyr)
INSTALLATIONSKORT
Minimumafstand fra kogezonerne: 43 cm (elplader), 65 cm (gas-, gasolie- eller
kulkogezoner)
ASENNUSOHJEET
Vähimmäisetäisyys liesistä: 43 cm (sähköliedet), 65 cm (kaasu-, öljy- tai hiililiedet)
INSTALLATION SHEET
Minimum height above cooker: 43 cm (electric cookers), 65 cm (gas, gasoil or
coal cookers)
S
N
DK
FIN
GB
CLOSED
OPEN
CLOSED
OPEN
1
2
22
3
3
Ø 2,5mm x
6mm max
4
5
6
7
7
6mm
7
8
9
10
11
DNV 3360 - DNI 3360
DNHI 3460 - DNHV 3460
5019 100 75017
AA
A
FF
F
12
14
Ø
135mm
16
15
17
10x10mm
13
25
23
23
22
22
20
19
21
20mm
16mm
CLOSED
OPEN
CLOSED
OPEN
25
24
24 24
OK!OK!
OK!
18
DNV 3360 - DNI 3360
DNHI 3460 - DNHV 3460
5019 100 75017
1.
Cotrol panel
2.
Grease filter (inside the extractor grille)
3.
Lighting unit
4.
Pull-out steam deflector
RENEWING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
Remove the burnt-out bulb and insert a new one.
Use only 40W max (E14) bulbs.
5.
Remount the extractor grille.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grille.
4.
Release the grease filter.
5.
Remove the dirty grease filter.
6.
After renewing or cleaning the grease filter
(depending on model) repeat the above
steps in reverse to reassemble, making sure
the entire extraction surface is covered.
MOUNTING OR RENEWING THE
CARBON FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grille.
4.
If a carbon filter is already mounted and
needs renewing, press the release buttons
(b) and pull the filter out downwards.
5.
If the filters are not mounted.
a.
fit the carbon filter into the upper clips.
b.
fasten using the lower clips.
6.
Remount the extractor grille.
CONTROL PANEL
A.
Light switch.
B.
Speed selector.
1.
Intensive extraction (only for models
DNHI 3460
and
DNHV 3460
).
1
4
2
3
0123
0I
aa
bb
CLOSED
OPEN
CLOSED
OPEN
25
24
24 24
C
A
B
small amount of steam and fumes
medium amount of steam and fumes
large amount of
steam and fumes
PRODUCT DESCRIPTION SHEET
DKS N FIN GB
/