OPERATION DESCRIPTION
Temperature adjustment is made with pushbutton (item 5).
Temperature setpoint is done for both compartments at
one time – fridge and freezer.
At first plug-in of appliance factory setpoint is chosen –
medium position (item 3).
Following table shows set-points level
Description:
LED OFF
LED ON
GUIDE TO SELECTING FUNCTIONS
Temperature selection pushbutton (item 5) is used to
set desired temperature level, from coldest to
warmest . At each short pressure of the
pushbutton, the setpoint will change (cyclically).
Fast Cooling function
The use of this function is recommended when placing a
very high quantity of food in the refrigerator
compartment.
By pressing and hold the button (item 5) for 3 sec. it is
possible to increase the cooling speed of the foods inside
the refrigerator compartment. The yellow LED (item 1)
will come on. The function is automatically deactivated
after 6 hours.
The "Fast cooling" function can be manually deactivated by
pressing and hold the same button (item 5) for 3 sec., the
yellow LED (item1) is off.
Note:
- Fast Cooling function should be also switched ON
before placing fresh food to be frozen in the freezer
compartment.
- Fast Cooling function has to be engaged in order to
maximize freezing capacity, thus it has to be engaged
before to add light load.
ABNORMAL APPLIANCE OPERATION
When the product is plugged in to the mains, during first
10 minutes of its performance, possible temperature
sensor failure will be displayed according to following
table:
Description:
LED OFF
LED Flashing
The appliance will work preserving the food stored, but it
is necessary to contact after-sales service and provide
alarm code.
Note: in case of power failure, appliance goes back to
normal operation and previously chosen setpoint is
restored.
DEFROSTING THE FREEZER
COMPARTMENT
No Frost freezers provide chilled air circulation around
the storage areas and prevent the formation of ice,
thereby completely eliminating the need for defrosting.
Frozen items don't stick to the walls, labeling stays legible
and storage space remains neat and clear.
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase is
in progress. The defrost water is automatically run into a
drain hole and collected in a container, where it
evaporates.
REPLACING THE LIGHT BULB
Always disconnect the refrigerator from the power supply
before replacing any light bulb.
If the inside light is not working, it is necessary to:
1. Remove the light cover:
move it upwards as
shown in figure.
2. Check the bulb. If
necessary unscrew the
broken bulb and replace
it with the new one.
3. Put on the light cover.
Do not leave the bulb uncovered.
CA
UKR
ROBGRUSHSKCZPLFINDKNSGRIPENLFGBD
PRODUCT SHEET
GB
Refrigerator
evaporator sensor
failure
Refrigerator sensor
failure
Refrigerator
evaporator &
refrigerator sensor
failure
5019 636 01014 Printed in Poland 05/11