2. Minka Group
  3. P5433-697-L

Minka Group P5433-697-L User manual

  • I have reviewed the installation instructions for the Light Fixture model P5433-697-L. This document covers the necessary steps for setting up your fixture, from initial preparation to mounting and wiring. It also notes the fixture's dimming capabilities. I'm ready to answer any questions you might have about the installation process or the features of this device.
  • What is the first step in installation?
    What size are the outlet box screws?
    What should I do with the ground wire if there is no ground wire on the outlet?
INSTALLATION INSTRUCTIONS
Item# P5433-697-L (Rev. 06/02/2023)
READ AND SAVE THESE INSTRUCTIONS
Fig.1
Set # A-020- 102A
- Mounting plate
- Outlet box screw* 2 pcs
- Ground Screw
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
( Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
( Neutral)
FIXTURE
WIRES
Bare
Coppe r
( Ground)
HOUSE
WIRES
Green
( Ground)
Page: 1/1
P5433-697-L
C
B
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PR
E
PARATION
1 . Shut off power at the fuse box or circuit breaker box.
If
necessary, remove the old fixture and mounting hardware.
2 . Carefully unpack your new fixture and lay out all the
parts
on a clear area. Take care not to lose any small
parts
necessary for installation.
MOUNTING THE FIXTURE (FIG. 1 )
3. Secure mounting plate (A) to the outlet box (not included)
using outlet box screws (B) (Size: #8-32N*L1
''
L). The
side
of the mounting plate (A) marked
“
GND
”
must face out.
CONNECTING THE WIRES (FIG. 2)
4 . Connect the electrical wires as shown in Fig. 2, making sure
that all wire connectors are secured. If your outlet has a
ground wire ( green or bare copper) , connect the fixture's
ground wire to it. Otherwise, connect the fixture' s ground
wire directly to the mounting plate (A) using the green screw
provided. After wires are connected, tuck them carefully
inside the outlet box.
COMPLETING THE INSTALLATION ( Fig. 1 )
5. Place the fixture’ s back plate ( C) over mounting plate (A
)
and secure with screws (D) .
Note: Illustration (Fig. 1) on this manual is for
installation purpose only. It may or may not be identical
to the fixture purchased.
IMPORTANT: Fixture should be installed by a
qualified
electrician to ensure proper wiring and installation.
Dimmable with ELV and/ or LED compatible wall dimmer
switch.
A
D
/