2. BLOTZ
  3. B20-ME-201

BLOTZ B20-ME-201, B20_ME_201, B28-ME-201 Assembly Instructions

  • Hello! I have reviewed the instructions for assembling the BLOTZ 20mm/28mm Ancient City Walls - 90 Degree Corner models, specifically the B20-ME-201 and B28-ME-201. This document details the steps for combining the various pieces, including the base, walls, supports, and crenellations, to create the corner section. I'm ready to help with any questions about the assembly process or the materials needed.
  • What type of glue is required?
    What tools will I need?
    Are the 20mm and 28mm versions assembled differently?
20mm/28mm Ancient City Walls – 90 Degree Corner
B20-ME-201 / B28-ME-201
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
wider connectors being the ones closest together.
Take the base and rear wall pieces.
Glue the supports to the rear wall, then attach the
whole assembly to the base (see pic).
Add the Additional supports for the front wall
(see pic).
Add the walkway section, gently slotting each lug
into the corresponding hole.
Add the front lower walls.
Add the crennalation pieces
Then attach the long strips.
The finished model.
/