Intermatic ET100 SERIES Programming Manual

Brand: Intermatic

Model: ET100 SERIES

Type: Programming Manual

ET100 SERIES EASY-SET BASIC PROGRAMMING

RESET TIME SWITCH:

1. Place the two position switch to AUTO and the three position

switch to RUN.

2. Press the RESET switch for 3-5 seconds to reset the

microprocessor memory and clear all programmed information. The

display will flash 12:00 AM.

NOTE: Do not press the RESET switch after programming has begun

or you will loose all of your programmed information.

TO SET PRESENT TIME OF DAY:

1. Place the two position switch to AUTO and the three position switch

to TIME SET.

2. Press the HOUR and MIN buttons separately to select the current

time of day. Note that this timer is a 12 hour AM/PM time clock.

TO PROGRAM TIMES :

1. Place the three position switch to PROGRAM. Note that the display

now shows 0:00 1 for Event #1. There are 8 possible programmed

times (events), 4 ON and 4 OFF. All available events need not be

used.

2. Press the HOUR and MIN buttons separately to program the first

ON time desired.

3. Press the EVENT button once. Note that the display now shows

0:00 2 for Event #2.

4. Press the HOUR and MIN buttons for the first OFF time. If more

than 1 ON and 1 OFF time (event) is required per day repeat this

procedure for up to 4 ON and 4 OFF times (events).

5. Return the three position switch to the RUN position and make sure

the two position selector switch is in the AUTO position.

TO REVIEW PROGRAMMED TIMES:

1. Place the three position switch to PROGRAM.

2. Press the EVENT button to review each of the 8 set points.

TO CHANGE PROGRAMMED TIMES:

1. Place the three position switch to PROGRAM.

2. Press the EVENT button until the desired time to change is

displayed.

3. Press the HOUR and MIN buttons separately to change the

displayed time to the new time desired.

4. Press the EVENT button to proceed to the next programmed event

to change if desired and follow previous procedure. If not return the

three position switch to the RUN position.

TO DELETE A PROGRAMMED TIME:

1. Place the three position switch to PROGRAM.

2. Press the EVENT button until the desired time to delete is

displayed.

3. Press the ON/OFF button twice to delete that time. The display will

now show 0:00 and the event number.

4. Return the three position switch to RUN.

TO OVERRIDE PROGRAM:

Program can be overridden at any time by placing the two position

switch to MANUAL. Programmed set times will be maintained but will

not operate the controlled load automatically.

TO MANUALLY OPERATE LOAD:

1. Place the two position switch to either MANUAL or AUTO.

2. Place the three position switch to RUN and depress the ON/OFF

button.

NOTE: The display will show your load toggle ON or OFF.

TO OPERATE TIMER:

Place the two position switch to AUTO and the three position switch to

RUN.

NOTE: When finished programming you may have to toggle your load

ON or OFF depending on the state it should be in at that time by

depressing the ON/OFF button.

NOTE: For assistance please contact Intermatic Technical Services at

815-675-7000.

Intermatic ET100 SERIES Programming Manual

Intermatic ET100 SERIES Programming Manual

Intermatic ET100 SERIES Programming Manual

Related papers

Other documents