dji Zenmuse H3-3D Assistant Software User guide

DJI H3-3D Anti-interference Reinforcement Board

Connection Chart

The Anti-interference Reinforcement Board is an accessory of the DJI H3-3D (For Phantom 2 Only

version ), you may follow the connection chart above to connect the Phantom 2 and H3-3D with

the board. Please pay attention to the Input and Output ports of the board. There are two ways

to mount the board, you can use a 3M double-side tape to fix it at the bottom of the Phantom 2,

OR you can mount the board directly inside the Phantom 2 as shown in the picture below.

8PIN Port (Phantom 2) 8PIN Port (H3-3D)

Anti-interference Reinforcement Board of H3-3D

Phantom 2

H3-3D

8PIN Cable of Phantom 2

8PIN Port of H3-3D

This manual is also suitable for

Download PDF