Arduino MKR IoT Carrier Rev2 Full Pinout

Arduino
Brand
Arduino
Model
MKR IoT Carrier Rev2
Type
Full Pinout
This work is licensed under
the Creative Commons
Attribution-ShareAlike 4.0
International License. To view a
copy of this license, visit http://
creativecommons.org/licenses/
by-sa/4.0/ or send a letter to
Creative Commons, PO Box 1866,
Mountain View, CA 94042, USA.
SKU code: ABX00073
Full Pinout - Page 1 of 5
Last update: 12 Jan, 2023
CIPO/COPI have previously been
referred to as MISO/MOSI
POWER LIMITS
Depend on the board used
Legend:
Power Power Input
Power Output
Ground
GPIO Digital External
Analog External
Main Part
Secondary Part
Internal Component
Other Pins (Reset, System
Control, Debugging)
LED
RGB LED
Other
TOP VIEW
+5V
VIN
+3V3
GND
RESET
D14
D13
D12
D11
D10
D9
D8
D7
INT
BUZZER
COPI
SCK
CIPO
SDA
SCL
DISP_CS
DISP_DC
DISP_RST
D6
AREF
Power
D0
D1
D2
D3
D4
D5
D15A0
D16A1
D17A2
D18A3
D19A4
D20A5
D21A6
ABT461RC
BUZZER
D7
LED_SDI
LED_CKI
DL1-A
DISP_BL
RELAY2
RELAY1
SD_CS
GROVE_AN6
TOUCH1
TOUCH5
TOUCH4
TOUCH3
TOUCH2
GROVE_AN0
APDS9306065 Light sensor
LSM6DSOX IMU sensor
This work is licensed under
the Creative Commons
Attribution-ShareAlike 4.0
International License. To view a
copy of this license, visit http://
creativecommons.org/licenses/
by-sa/4.0/ or send a letter to
Creative Commons, PO Box 1866,
Mountain View, CA 94042, USA.
SKU code: ABX00073
Full Pinout - Page 2 of 5
Last update: 12 Jan, 2023
CIPO/COPI have previously been
referred to as MISO/MOSI
POWER LIMITS
Depend on the board used
Legend:
Power Power Input
Power Output
Ground
GPIO Digital External
Analog External
Main Part
Secondary Part
Internal Component
Other Pins (Reset, System
Control, Debugging)
LED
RGB LED
Other
TOP VIEW
18650 Li-Ion 3.7 V
1
GROVE I2C
MKR Board
SCL
D12
2
SDA
D11
RLY_2
RELAY2
D2
GND
-BAT
VBAT
+BAT
3
+5V
4
GND
1
GROVE A0
GROVE_AN0
3
+5V
4
GND
A0 D15
1
GROVE A6
GROVE_AN6
3
+5V
4
GND
A6 D21
SD Card reader
3CMD/COPI D8
6CLK/SCK D9
7DAT0/CIPO D10
2CD/DAT3/SS D0
DL3-L2
RLY_1
RELAY1
D1DL2-L1
To supply with battery, plug the battery
connector over the MKR board to the
battery connector over the MKR IoT Carrier
MAXIMUM voltage of 30V
for each Relay Connector
WARNING!
Advanced Section
The following information is for advanced use only and
may not be officially supported by Arduino software
This work is licensed under
the Creative Commons
Attribution-ShareAlike 4.0
International License. To view a
copy of this license, visit http://
creativecommons.org/licenses/
by-sa/4.0/ or send a letter to
Creative Commons, PO Box 1866,
Mountain View, CA 94042, USA.
SKU code: ABX00073
Full Pinout - Page 4 of 5
Last update: 12 Jan, 2023
CIPO/COPI have previously been
referred to as MISO/MOSI
POWER LIMITS
Depend on the board used
Legend:
Power Power Input
Power Output
Ground
GPIO Digital External
Analog External
Main Part
Secondary Part
Internal Component
Other Pins (Reset, System
Control, Debugging)
LED
RGB LED
Other
BOTTOM VIEW
IMU 6-AXIS
LSM6DSOX
9INT D6
13 SCL D12
14 SDA D11
A5 D20
TOUCH1
Y1
A1 D16
TOUCH2
Y2
A2
TOUCH3
D17 Y3
A3D18
TOUCH4
Y4
A4D19
TOUCH5
Y5
X
Y
Z
SFV24R
24
LEDA
LV52204MTTBG
SW
23
LEDK
FB
13
COPI
D8
15
DISP_DC
D14
16
SCK
D9
17
DISP_CS
D13
18
DISP_RST
RESET
DISP_BL
5-SWIRE D3
The connector SFV24R works
with the round LCD screen.
It is present in the Oplà IoT
Kit (AKX00026) and MKR IoT
Carrier (ABX00047) version.
KD013QVFMD002-01
This work is licensed under
the Creative Commons
Attribution-ShareAlike 4.0
International License. To view a
copy of this license, visit http://
creativecommons.org/licenses/
by-sa/4.0/ or send a letter to
Creative Commons, PO Box 1866,
Mountain View, CA 94042, USA.
SKU code: ABX00073
Full Pinout - Page 5 of 5
Last update: 12 Jan, 2023
CIPO/COPI have previously been
referred to as MISO/MOSI
POWER LIMITS
Depend on the board used
Legend:
Power Power Input
Power Output
Ground
GPIO Digital External
Analog External
Main Part
Secondary Part
Internal Component
Other Pins (Reset, System
Control, Debugging)
LED
RGB LED
Other
BOTTOM VIEW
L2
D13DL3-L2
L1
RLY_2
RELAY2
RLY_1
RELAY1 D14
D11
DL2-L1
3
SDA
D12 4
SCL
BME688
Pressure-temperature-air
sensor
D11 1
SDA
D6 2
INT
D12 7
SCL
APDS-9660
Light sensor
00 01 02 03 04
LED_CKI D4 CK0
LED_SDI D5 SDO0
CK1
SDO1
CK2
SDO2
CK3
SDO3
CK4
SDO4
00 01
04 03
02
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Arduino MKR IoT Carrier Rev2 Full Pinout

Arduino
Brand
Arduino
Model
MKR IoT Carrier Rev2
Type
Full Pinout
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents