1of4
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
150W
MAX
1BULBREQUIRED
BULBNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker before installation.
Consult a licensed electrician if in doubt about installation.
Turn off power to the fixture and allow the bulbs to cool before
replacing.
Crossbar
Assembly
x1
A
Package Contents
PARTS BAG
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Fixture Body
x1
E
Crossbar
Assembly Wiring
Bulb
Table of
Contents
STEP 3 STEP 4
STEP 6
Fixture Body
STEP 5
Alternate
Mounting
Screw
x2
B
Alternate
Mounting Screw
STEP 2
Outlet Box Screw
x2
C
Wire Connector
x3
D
Remove Styrofoam
STEP 1
STEP 7 STEP 8
Caulk Replace Glass
Installation Instructions: UQL1583
www.urbanambiance.com
STEP 1
STEP 3 1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting backplate to mounting screws
2of4
STEP 2
OPTION 1 OPTION 2
Included
(Pre-assembled)
Included
Standard
Mounting
Screw
Alternate
Mounting
Screw
skip to next page
1 2 3
Steps 1-3 to remove standard mounting screws
56
Steps 4-6 to reassemble with alternate mounting screws
4
www.urbanambiance.com
3of4
STEP 5
STEP 6
*Green Ground Screw
on crossbar optional
White wire (neutral)
from outlet box
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
STEP 4
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
www.urbanambiance.com
STEP 8 - How to Replace Glass
4of4
1 2
Remove glass holder Replace glass
3
Reinstall glass holder
STEP 7
Exterior Caulk
www.urbanambiance.com
/
