2. BLOTZ
  3. B28-ST-148

BLOTZ B28-ST-148, B28-ST-149 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the Shed B28-ST-148. This document details the process of putting together a 28mm scale model using glue and a modeling knife. It also covers a method to create an open door using a detaching sprue. I'm ready to answer any questions you have about this model's assembly.
  • What type of glue is needed?
    What tool is needed to remove parts from the sprue?
    What can be used to hold the pieces in place while the glue dries?
    Can the door be positioned open?
28mm Shed #1
B28-ST-148
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the base and four walls (shown above) from the
sprue.
Glue them together as shown.
Note: The door has a sprue point on the top of it, so
it can be detached and glued into an “open” position
if required.
Take the roof pieces.
Glue the two triangular supports to the back of one
roof section.
Then attach the other roof section.
The completed model.
/