Wi3 WiPSM1 Installation guide

Brand
Wi3
Model
WiPSM1
Type
Installation guide
A
D
B
B
C
C
E E
A Standard opening to permit access to the
in-wall coaxial cable
B Screw hole location for junction box or low
voltage bracket surface mount installation
C 10cm VESA screw holes
D Exit point for the WiPNET dongle when
using the VESA mount installation option
E Screw hole location for European surface
mount installation option
To install over an existing wall opening:
1. Ax the backplate to junction box or
low voltage bracket using holes “B” and
screws provided
2. Screw in-wall coax cable connecter onto
end of WiPNET sleeve’s coax dongle, and
slide the sleeve into the backplate, being
careful not to pinch the dongle
3. Snap cover over sleeve, attach desired
cables to WiPNET cartridge, and insert
into the sleeve
To install onto the back of an HDTV:
1. Ax backplate to VESA mount interface
on the back of your HDTV (HDTV cannot
be wall-mounted) using one or both of
holes “C” – VESA screws* not provided
2. Thread your WiPNET sleeve’s coax dongle
through opening “D” and slide the sleeve
into the backplate, being careful not to
pinch the dongle
3. Snap cover over sleeve
4. Screw desired coax cable connecter onto
end of WiPNET sleeve’s dongle
5. Attach desired cables to WiPNET cartridge
and insert into the sleeve
* VESA screws have an M4 thread
and are typically 10 mm deep
™
wired
wireless
wideband
  • Page 1 1

Wi3 WiPSM1 Installation guide

Brand
Wi3
Model
WiPSM1
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents