2. Eastwood
  3. Welding Cart
Welding Cart

Eastwood Welding Cart, Welding Cart Drawers Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Eastwood Welding Cart Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
MIG WELDER/PLASMA CUTTER CART
4 DRAWER CABINET
INSTRUCTIONS
Part #20181
© Copyright 2014 Easthill Group, Inc. Instruction part #20181Q Rev. 6/14
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com
PDF version of this manual is available online >> eastwood.com/20181manual
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
US and Canada: 800.345.1178 Outside US: 610.718.8335
Fax: 610.323.6268 eastwood.com
The Eastwood 4 Drawer Welding Cart Cabinet is constructed of heavy-gauge, powder-coated steel to provide years of rugged and reliable service.
It is designed to fit the Eastwood #20232 MIG Welder/Plasma Cutter Cart and features lockable, telescoping glide drawers.
INCLUDES
(1) 4 Drawer, Lockable Cabinet (1) Mid-Shelf Panel (2) 6mm Bolts & Washers (2) Keys
NOTE: The Mid-Shelf Panel, Hardware and Keys are shipped in the top drawer.
REQUIRED TOOLS
• 10mm wrench
ASSEMBLY
NOTE: The Mid Shelf Panel is designed to replace the Center Shelf (F) of the Eastwood #20232 MIG Welder/Plasma Cutter Cart.
This shelf along with the Lower Shelf Edge may be discarded. (Please retain 4 sets of 6mm Bolts, Washers & Nuts.)
INSTALLING MID-SHELF TO REAR PANEL AND THE REAR OF 4 DRAWER CABINET:
NOTE: The four edges of the Mid-Shelf (F) have bent flanges. Install Mid-Shelf with flanges facing upward.
1. Align the Mid-Shelf’s two long-flange holes with two holes in the upper rear panel of the 4 Drawer Cabinet.
Apply washers to two 6mm Bolts and thread into the rear of 4 Drawer Cabinet.
2. Tighten bolts only “finger-tight” to allow for alignment in following steps.
3. Align the Mid-Shelf’s two end-flange holes with the two holes in the Rear Vertical Panel, (E) of the Eastwood #20232 MIG Welder/Plasma Cutter Cart.
Place two 6mm Bolts through holes and apply Washers & Nuts.
4. Tighten all hardware.
E
F
✓
✓
/