1. Introduction

The OnQ Digital Cable Bypass Kit, OnQ P/N 364557-01, is used to allow in-house modulated signals to be viewed on TV’s

with digital set top boxes for general CATV viewing.

2. Description

The Digital Cable Bypass Kit includes channel 2-4 notch filter, two (2) 2:1 splitter/combiners and two (2) 9” coax jumper cable

assemblies. (The notch filter blocks channels 2-4, but allows channels 5 and higher to pass.)

3. Installation - Digital Bypass Kit installs in the room with the digital set top box.

A. Connect the cable from the

jumpers.

C. Connect the “OUT” port of

the notch filter to the “OUT”

port of the 2nd splitter using

the other coax jumper

assembly. (This 2nd splitter

is actually used as

combiner.)

D. Connect the “OUT” of the

1st splitter (for the wall

F. Connect the splitter/combiner

“IN” port to the TV.

G. Verify that the in-house

modulated signal is clear

and visible on the

appropriate channel.

Tune TV to channel 3 or 4

and verify set top box can

tune and pre-set all

channels.

higher. P/N 364456-03 allows channels 2-116 to pass and blocks channel 117 and higher.

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106-0907

800-321-2343

www.onqtech.com

Installation/Instruction Sheet

IS-0184 Rev. B Page 1 of 1