2. TANDBERG
  3. Edge MXP Series

TANDBERG Edge MXP Series Installation guide

  • Hello! I am an AI chatbot trained to assist you with the TANDBERG Edge MXP Series Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Tandberg Edge Installation
Step 1 Step 2
1. Plug the black RCA connector on one end of Cable C into Tandberg video-station <Audio Out 1>, and then plug
the black RCA connector on the other end into the Fusion Base Station <Conf In>. The other RCA connector is
not used.
2. Plug one XLR connector of Cable D, XLR to XLR, into Tandberg video-station <Mic 1 Input> and the other XLR
connector into the Fusion Base Station Mic Level Output <XLR>.
To configure the Tandberg system:
Select the button from the main screen to access the System menu.
Go to Audio settings
Confirm or modify the following settings:
• Input 1 - MIC
• Output 1 - ON
• Audio Leveling - OFF
• Echo Canceller and Noise Reduction (EC and NR) - OFF
Adjust the audio Input Level if necessary.
Speak into the Revolabs microphones that are connected to the audio line inputs.
The audio meter should peak at about 5 dB.
Tandberg Set Top MXP Installation
Step 1 Step 2
1.
Plug the black RCA connector on one end of Cable C into Tandberg video-station <Audio Out 1>, and then plug
the black RCA connector on the other end into the Fusion Base Station <Conf In>. The other RCA connector is
not used.
2. Plug one XLR connector of Cable D, XLR to XLR, into Tandberg video-station <Mic 1 Input> and the other XLR
connector into the Fusion Base Station Mic Level Output <XLR>.
To configure the Tandberg system:
Select the button from the main screen to access the System menu.
Go to Audio settings
Confirm or modify the following settings:
• Input 1 - MIC
• Output 1 - ON
• Audio Leveling - OFF
• Echo Canceller and Noise Reduction (EC and NR) - OFF
Adjust the audio Input Level if necessary.
Speak into the Revolabs microphones that are connected to the audio line inputs.
The audio meter should peak at about 5 dB.
Tandberg Profile MXP Installation
Page2
Step 1 Step 2
1. Plug one XLR connector of Cable D, XLR to XLR, into Tandberg video-station <Mic 1 Input> and the other XLR
connector into the Fusion Base Station Mic Level Output <XLR>.
2. Plug the black RCA connector on one end of Cable C into Tandberg video-station <Audio Out 1>, and then plug
the black RCA connector on the other end into the Fusion Base Station <Conf In>. The other RCA connector is
not used.
To configure the Tandberg system:
Select the button from the main screen to access the System menu.
Go to Audio settings
Confirm or modify the following settings:
• Input 1 - MIC
• Output 1 - ON
• Audio Leveling - OFF
• Echo Canceller and Noise Reduction (EC and NR) - OFF
Adjust the audio Input Level if necessary.
Speak into the Revolabs microphones that are connected to the audio line inputs.
The audio meter should peak at about 5 dB.
/