2. Crystorama
  3. 2249-BF
2249-BF

Crystorama 2249-BF User manual

  • I've reviewed the assembly instructions for the CRYSTSTORAMA 2249-BF light fixture. This document outlines the steps for safely assembling and installing the fixture, including spreading the arms, mounting it to the ceiling, and adding shades and bulbs. I'm ready to answer your questions about this product.
  • What type of bulbs does the light fixture use?
    What is the recommended wattage for the bulbs?
    Is this fixture suitable for wet locations?
    What is the model number of the fixture?
ASSEMBLYINSTRUCTIONMODEL#2249-BF
CRYST
RAMA
WARNING:
ElectricalDanger TurnPoweroff
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Howtoinstall
9.Installthebulbs(notincluded)intothesocket.
Youwillneed8-CandelabraBaseBulb
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
This fixture is Dry rated
8.Installthefabricshadeontothecandlesleeve.
2.Sliptheloopalongwireandthreadontothenipple
ofarmassembly.
1.Removethescrewfromeachoftheholesonthemetal
frame.Aligntheholesonthetabsofthearmassembly
withtheholesonthemetalframeandsecuretogether
usingthescrewsthatwereremoved.
SPREAD THE ARMS TO A SUITABLEPOSITION
OUTLET BOX SCREW
LOOP
WALL ANCHOR
ANCHOR SCREW
MOUNTING PLATE
MOUNTING SCREW
CANOPY
CHAIN
LOOP
NIPPLE
ARMS SCREWS
(Thescrewsfrommetalframe)
METAL
FRAME
BOTTOMFINIALS
3.Placethemountingplateovertheoutletbox.Mark
fourpointsontheceilingatthecenterofthekeyhole
onthemountingplate.
4.Drillfourholesatthemarkedpointsandinsertthe
wallanchors.
5 Placethemountingplateovertheoutletboxand
secureitwithtwooutletboxscrews.Insertthe
anchorscrewsintothewallanchors
(Installedinstep#5)andtighten.
.
6.Determinethepreferredhangingheightandadjustto
thechainrequired.
7.Installcanopyontothemountingplate,andsecure
withthemountingscrews.
25’’
21-1/4”
3/4’’
42’’
147-3/4’’
4-1/2”
18’’
FABRIC
SHADE
4’’
3’’
4-1/2’’
FABRIC SHADE
CANDLE
SLEEVE
Crystorama.com
CRYST
RAMA
L I G H T I N GT H EW A YF O RS I X T YY E A R S
ASSEMBLYINSTRUCTIONMODEL#2249-BF
Part Number
PartNumbers
A.(1)-Mounting hardware
B.(1)-Mountingplate
C.(4)-Mountingscrew
D.(1)-CanopyW4-1/2’’xL21-1/4’’xH3/4’’ #XRF2249BFCAN21.25IN
E.(4)-Loop
F.(2)-Chain-120’’,4mmthick#XRF2248BFCHA4.0MM
G.(8)-Screw
H.(1)-Metalframe
I.(4)-Bottomfinial
J.(8)-FabricshadeW4’’xH4-1/2’’ #XRF2243SHA4.5IN
K(A).(8)-Candlesleeve-BFW7/8’’xL2-3/8’’ #XRF2243BFCDL2.375IN
K(B).(8)-Candlesleeve-WHW7/8’’xL2-3/8’’ #XRF2243WHCDL2.375IN
A
B
C
D
E
F
E
G
H
I
J
K
Crystorama.com
/