Etec E1450C Assembly Instructions Manual
- Category
- Flat panel floor stands
- Type
- Assembly Instructions Manual
Maximum Weight Capacity:
Top Shelf: 140 Lbs
Middle Shelf: 40 Lbs
Bottom Shelf: 50 Lbs
MODEL E1450C
ASSEMBLY INSTRUCTIONS
Important! Read all warnings before starting assembly.
For technical assistance or troubleshooting
please call 1-855-994-3832.
2 E1450C
READ THIS FIRST!
Read all of the warnings and cautions contained
in this manual before assembly.
• Do not attempt to assemble this product if you
do not understand the instructions.
• Contact a professional if you have any doubts
about safe and secure TV furniture assembly.
• Check all the parts carefully to make sure there
are no missing or damaged parts.
• Improper assembly may result in damage to
your TV, property, and personal injury.
• This product is intended only to support a
television of the indicated size and weight
combination. Using this product to support
televisions heavier than the maximum weight
capacity can damage product and cause
personal injury.
• Schoenfeld International Inc. and ETEC are not
responsible for any personal injury or product
damage due to mishandling, incorrect mount-
ing, incorrect assembly or incorrect use of this
product.
CHILD SAFETY WARNINGS
How and where you use your television stand is
extremely important for Child Safety
As you set up and use your new product, keep all
of these safety tips in mind
! Don't let children climb on or play with enter-
tainment system furniture and TVs.
! Remember that children can become excited
while watching a program, especially on a
"larger than life" TV. Make sure to place or
install the TV stand where it cannot be pushed,
pulled over, or knocked down.
! Make sure that you route all cords and cables
so that they cannot be pulled or grabbed by
curious children.
WARNINGS
• This product is intended only to mount a televi-
sion of the indicated size and weight combina-
tion. Using this product to support televisions
or other products heavier than the maximum
weight capacity can damage equipment and
cause personal injury.
• Schoenfeld International Inc. and ETEC are not
responsible for any personal injury or product
damage due to mishandling, incorrect mount-
ing, incorrect assembly or incorrect use of this
product.
• Do not force the bolts into the hole or use an
electric drill to fasten any bolts. This could
damage the equipment or cause personal
injury.
• A large television requires two people to lift.
Schoenfeld International and ETEC are not
responsible for equipment damage or personal
injury due to mishandling.
• Do not release the TV until you are sure that it
is securely mounted. Releasing the TV without
first ensuring that it is securely installed can
result in equipment damage or personal injury.
CAUTION:
• Do not place the TV face down on a hard
surface when installing the mounting plate on
the TV. Placing the TV face down on a hard
surface can result in equipment damage. Use
a blanket or other suitable surface.
• Check with your TV manual or manufacturer to
confirm the required bolt diameter according to
the size, depth, and position of the mounting
holes in your TV.
FOR YOUR SAFETY, PLEASE FOLLOW
THESE PRECAUTIONS:
Always remove the TV and other equipment
from the furniture prior to moving the
assembled unit.
E1450C 3
! Be careful when moving the assembled furni-
ture after the glass shelf has been installed, or
when there is equipment of any kind located
on the furniture as this may cause the shelves
and other parts to become unstable and fall.
! When in use, this furniture must be placed on
a flat, level and solid surface.
! Do not lean on or place any force on the TV
when it is on the TV stand.
! Do not climb or step on the stand
.
! Do not bang into or place your own weight on
the glass sheves
! Do not place any items on the shelves or
mounts which may exceed the maximum
weight limits.
! Always place the heaviest component (except
for your TV) on the bottom shelf
Schoenfeld International Inc. and ETEC will not
be responsible for failure to assemble as directed
or for the improper assembly, use or handling of
this stand.
VEILLER Á RESPECTER CES MESURES DE
PRECAUTION!
TOUJOURS ENLEVER LE TÉLÉVISEUR ET
AUTRE ÉQUIPEMENT AVANT DE
DÉPLACER LE MEUBLE ASSEMBLÉ.
! DÉPLACER LE MEUBLE AVEC PRÉCAU-
TION UNE FOIS QUE LE PLATEAU EN
VERRE A ÉTÉ POSÉ OU LORSQU’IL Y A DU
MATERIEL PLACÉ SUR LE MEUBLE CAR
CELA PEUT CAUSER LE DÉCROCHEMENT
ET LA CHUTE DES PLATEAUX ET AUTRES
ÉLÉMENTS.
! DURANT L’UTILISATION, LE MEUBLE DOIT
ÉTRE POSÉ SUR UNE SURFACE PLATE,
SOLIDE ET HORIZONTALE.
! NE PAS S'APPUYER CONTRE LE TÉLÉVI-
SEUR LORSQU'IL EST POSÉ SUR LE
MEUBLE.
! NE PAS GRIMPER NI MARCHER SUR LE
MEUBLE.
! NE PAS TAPER NI S'APPUYER SUR LE
PLATEAU EN VERRE
Schoenfeld International Inc. y ETEC decline
toute responsabilité en cas d’assemblage non
conforme aux instructions ou pour l’assemblage,
l'utilisation ou la manutention incorrects de ce
meuble.
POR SU SEGURIDAD TENGA LAS SIGUIEN-
TES PRECAUCIONES:
! SIEMPRE QUITE EL TELEVISOR Y CUAL-
QUIER OTRO EQUIPO DEL MUEBLE ANTES
DE MOVER LA UNIDAD ARMADA.
! TENGA CUIDADO AL MOVER LA UNIDAD
ARMADA UNA VEZ INSTALADO EL
ESTANTE DE VIDRIO Y/O CUANDO HAYA
ALGUN EQUIPO EN EL MUEBLE YA QUE
ESTO PODRÍA AFLOJAR EL ESTANTE Y
OTROS ARTÍCULOS Y HACER QUE SE
CAIGAN.
! EL MUEBLE DEBE ESTAR UBICADO EN
UNA SUPERFICIE PLANA, SÓLIDA Y NIVE-
LADA CUANDO SE LO ESTE UTILIZANDO.
! NO INCLINE EL TELEVISOR CUANDO ESTE
EN EL SOPORTE PARA TV.
! NO SE SUBA NI SE PARE SOBRE EL
SÓPORTE.
! NO GOLPEE EL ESTANTE DE VIDRIO NI SE
APOYE CON SU PESO SOBRE EL MISMO
Schoenfeld International Inc. y ETEC no se hara
responsable en caso de que no se instale la
base segun las instrucciones, ni de la insta-
lación, uso o manejo incorrectos de esta base.
4
E1450C
LIMITED SIX-YEAR FURNITURE WARRANTY
We warrant this product to you, the original purchaser at the time of purchase printed on a dated store receipt from
an authorized ETEC retailer and for a period of six-years thereafter that our furniture product and all it’s parts and
components are free of defects in material and workmanship under normal use. This warranty is subject to the
provisions below. ETEC’s sole obligation and the purchaser’s exclusive remedy pursuant to these warranties are
limited to replacement at ETEC’s sole discretion. There are no other warranties except as expressively set forth
below either expressed or implied, including any warranty of merchantability for any particular purpose.
Should you be missing any of the assembly parts or components (screws, pieces, etc.), please contact the
Technical Support Center to secure a replacement for those parts. It is not necessary to bring the entire unit back
to the store. When calling, please use the parts list found in the Instruction Manual to help us accurately identify
the missing parts so we can promptly provide replacements.
Our Customer Support Center is available Monday - Saturday (10:00AM to 7:00PM EST) for technical assistance
or troubleshooting. To contact us, please call 1-855-994-3832.
This warranty is expressly limited to the replacement of furniture parts and components described in the parts list
located in the Instruction Manual included with the product.
This warranty applies under conditions of normal use.
This warranty does not cover: any product, which has been subject to damage due to improper assembly or
disassembly, products which were not assembled, installed, used, or maintained in accordance with the product
assembly instructions & warnings, acts of nature, misuse, neglect, accidents, abuse, exposure to elements,
outdoor use, extreme temperature ranges, damage during transit, commercial use, modification of, or to any part
of the product or attachments to the product not approved by ETEC. Also not covered are costs for
assembly/dis-assembly labor, costs incurred in shipping the unit or parts for warranty repair/exchange or any
products purchased from unauthorized ETEC sellers. Under no circumstances shall ETEC, be liable for any loss
(direct, indirect, incidental, foreseen, unforeseen, special or consequential) or for any damage arising out of, or in
connection with, the use of this product. Nor shall ETEC have any responsibility for incidental or consequential
damages resulting from the breach of this warranty including but not limited to inconvenience, purchase or rental
of replacement products, loss of profits or commercial loss.
We reserve the right to request damaged parts or units be shipped to our offices for inspection or confirmation of
any warranty claims.
This warranty does not cover product sold ‘As Is’.
This warranty is valid only to the original purchaser of the Product in the United States and Canada and grants
specific legal rights.
E1450C 5
PARTS
2X1
3X1
4X1
5X1
6X1
7X1
8X1
9X1
1X1
BX18
CX4
DX1
M6x12mm
M6x32mm
AX12
12
0
15
58
38
20
32
STEP 1
E1450C6
+
A
1
2
3
4
D
M6x32mm
AX6
+
E1450C 7
STEP 2
A
5
6
+
M6x32mm
AX6
D
+
8 E1450C
STEP 3
+
B
B
BX18
E1450C 9
STEP 4
+
C
7
8
9
CX4
M6x12mm
D
+
E1450C 10
E1450C 11
This page is intentionally left blank
Schoenfeld International Inc and ETEC
5001 American Boulevard West
Suite 275
Bloomington, Minnesota 55437
©Schoenfeld International Inc., 2013
E1450C Ver. 1.1 October 2013
12 E1450C
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Etec E1450C Assembly Instructions Manual
- Category
- Flat panel floor stands
- Type
- Assembly Instructions Manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Etec E1630C Assembly Instructions Manual
-
-
-
-
-
-
-
-
-
