Vita CLASSIC Liberty Elevated Garden Installation guide

Type
Installation guide

This manual is also suitable for

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346
(Mon. to Fri. 8:00 AM to 5:00 PM EST).
1. Pre-Assembled Left Side Wall Panel with Posts Connected (1)
2. Pre-Assembled Right Side Wall Panel with Posts Connected (1)
3. Pre-Assembled Front Wall Panel (1)
4. Pre-Assembled Rear Wall Panel (1)
5. Post Caps (4)
6. Floor Boards (4)
7. Corner Braces (2)
8. Left Brace (1)
9. Center Brace (1)
10. Right Brace (1)
11. 2 ½” Self-Auguring Stainless Steel Screws (8)
General Information
Read Instructions through carefully before beginning assembly.
When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
We recommend an area approx 4’x 8’ for unobstructed assembling.
You should not need to use excessive force when assembling components.
Wheelchair Accessible Raised Planter Box
Please read through before starting assembly.
ASSEMBLY IN ST RUC TIONS
1
Not to Scale
5
7
10
4
Ver 1.1/131120
8
1
11
9
24 in
17 in
41 3/8 in
47 3/8 in
41 in
48 in
29 1/4 in
38 1/2 in
44 1/2 in
49 1/2 in
25 1/2 in
19 1/2 in
43 1/2 in
6
3
2
www.wearevita.com
4
3
2
2
STEP ONE
Lay the pre-assembled left side wall with posts connected on its
side as shown and insert the pre-assembled rear wall panel.
Excessive force should not be used. Insert until the rear wall panel
bottoms out inside the post.
Secure the rear panel in place using two of the screws provided
through the pre-drilled holes.
Similarly, insert the pre-assembled front panel as shown.
Insert until the front wall panel bottoms out inside the post.
Secure the front panel in place using two of the screws provided
through the pre-drilled holes.
1
Wheelchair Accessible Raised Planter Box Instructions
1
3
2
4
3
STEP TWO
Wheelchair Accessible Raised Planter Box Instructions
3
2
Insert the pre-assembled right side wall with posts connected to
the assembly from the previous step. Excessive force should not be
used. Insert until the front and rear wall panels bottoms out inside
the posts.
Carefully stand the assembly up as shown.
While ensuring that the front and rear walls are bottoming out
inside the posts, secure the front panel in place using two of the
screws provided through the pre-drilled holes
Repeat step 2 for the rear panel.
1
1
3
2
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
4
STEP THREE
2
Connect the center brace between the front and rear wall panels
as well as the two corner braces between the rear and side panels
as shown. Excessive force should not be used.
Note that the corner braces will only connect one way.
Connect the left and right braces between the corner braces and
front wall panel as shown.
Note that the left and right braces will only connect one way.
1
Wheelchair Accessible Raised Planter Box Instructions
1
2
Toll Free Phone: 1 800 282 9346
www.wearevita.com
5
STEP FOUR
3
2
Insert one of the notched floor boards onto the brace assembly
as shown. The notched corners should be nested inside the posts.
One by one, add the remaining floor boards.
Note that there are different types of boards and they are
tounge-and-grooved to lock into each other.
Pressure fit the four post caps onto the posts as shown.
1
1
3
2
Notched
Tounge & groove
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Vita CLASSIC Liberty Elevated Garden Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI