none Va68211 Installation guide

Type
Installation guide
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346, ext #20
(Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Pre-Assembled Front & Back Wall Panels with Posts Connected (2)
2. Floor Panels (3)
3. Floor Supports (3)
4.
Pre-Assembled Side Wall Panels
(2)
5. Shelf Boards (10)
6. Post Caps (4)
7. 5/8” Stainless Steel Screws (8)
General Information
Read Instructions through carefully before beginning assembly.
When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
We recommend an area approx 4’x 8’ for unobstructed assembling.
You should not need to use excessive force when assembling components.
The Cambridge Raised Planter Box
Please read through before starting assembly.
A S S E M B LY I N S T RUCTIONS
7
1
www.edenarbors.com
Not to Scale
1
4
3
2
Ver 2.0/SEPT 2011
36 in
35.38 in
5.75 in
24.0 in
5
6
Align and insert the front wall to the assembly, ensuring all the
shelf boards snap into place and side walls are inserted.
Using the provided 5/8 screws, fasten the side wall to the
front and back wall from the inside of the posts as shown.
Each post will use two screws.
The Cambridge Raised Planter Box
4
5
www.edenarbors.com
Insert the shelf boards into the routed holes on the bottom rail.
Push until the locking tabs snap into place.
Insert the two side walls into the back wall panel as shown.
Note the tabbed rail will go on the bottom.
3
2
2
S TE P O N E
Lay out back wall panel on the work surface.
Connect the Shelf Boards
to the Back Wall
1
2
3
4
5
The Cambridge Raised Planter Box
Note Tab
The Cambridge Raised Planter Box
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.edenarbors.com
Place the three floor panels onto the floor supports as shown.
Note the notches on the one side of the two panels. These
notches are to wrap around the posts.
Pressure fit the post caps into place. Push until they snap into
place.
3
3
2
S T E P T W O
Place three floor supports onto the notched sections of the
front and back walls.
Insert The Floor Panels
1
1
2
3
  • Page 1 1
  • Page 2 2
  • Page 3 3

none Va68211 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI