BARRON WLZ Series Low-profile Installation guide

Brand
BARRON
Model
WLZ Series Low-profile
Type
Installation guide
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations, if
applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
Technical Support ■ (623) 580-8943 ■ [email protected]
WLZ
Installation Instructions
20070121 REV 4 - 05/21 1 800-533-3948 www.barronltg.com
Installation
1. Open the fixture by removing the (2) mounting screws on the bottom of the
fixture. (Fig. 1)
2. Remove the appropriate knockouts for mounting the back enclosure to the
J-box by following the J-box mounting chart. (Fig. 2 and Table 1)
3. Make electrical connections; see Electrical Connections section.
4. Check that the gasket is properly adhered to back of the fixture,
then secure the back enclosure to the J-box. Ensure that the back
enclosure is level with the ground using the built-in leveling bubble.
(Fig. 3)
Note: Fixture is intended for downlight only.
5. Align the front enclosure with the hinge located on the top of the
back enclosure, then swing the front enclosure down to close the
fixture.
6. Reinstall the (2) Philips head screws.
IMPORTANT: Weatherproof your outdoor installation. Be sure to
seal all holes in the enclosure, such as the mounting, conduit, plugs,
sensors, and photocontrols with silicone sealant.
Apply sealant
across top edge of the wall pack between the back enclosure and
the mounting surface to prevent water from reaching the back of the
enclosure.
Fig. 1
Fig. 2
(2) Philips Head Screws
CB
A
G
F
E D D E
F G
ABC
A-A
4” Square Box
B-B
4” Octagonal Box
C-C
3-1/2” Square/Octagonal Box
D-D
Masonry Box
E-E
4” Round Box
F-F
2-3/4” Hold Pattern
G-G
Single Gang
Table 1 - J-Box Mounting Chart
Front
Enclosure
Gasket
J-Box
(Not Supplied)
Back Enclosure
Plug
Gasket
Leveling
Bubble
Hinge
Fig. 3
WLZ
Installation Instructions
20070121 REV 4 - 05/21 2 800-533-3948 www.barronltg.com
Fig. 4 - WLZ1, WLZ2, WLZ4, WLZ10
Electrical Connections (Fig. 4-6)
All electrical connections should be made inside the junction box. Make electrical connection as follows:
120-277VAC
Black - 120-277VAC
White - Common
Connect the ground wire to the green grounding screw.
Note: Cap unused leads to prevent shorting.
Note: This fixture auto-adjusts for voltages from 120-277VAC.
Fig. 5 - WLZ7 (Standard)
WLZ4, WLZ10 (Dual Driver Option)
Photocontrol
LED Driver
Black - 120-277VAC
White - Common
Hot
Load
Line
Neutral
Common
Photocontrol
LED Driver
Black - 120-277VAC
White - Common
Hot
Load
Line
Neutral
Common
LED Driver
Hot
Common
WLZ
Installation Instructions
20070121 REV 4 - 05/21 3 800-533-3948 www.barronltg.com
Electrical Connections, Continued
Fig. 6 - Fixtures with Battery Backup (BB Option)
Emergency
Driver
LED Driver
Battery
LED Panel V VIIV
Enclosure
Ground
Screw
Battery
Connector
I
II
III
White
Black
Black
Green
Test
Switch
Purple Grey
Black
Black
White
Green
Purple
Grey
Switch Line
Unswitched Line
Common
Ground
DIM(+)
DIM(–)
Existing Wire Connection
Wire Connection
with Identifying Roman Numeral
Legend
I
I
II
III
IV
V
VI
WLZ
Installation Instructions
20070121 REV 4 - 05/21 4 800-533-3948 www.barronltg.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

BARRON WLZ Series Low-profile Installation guide

Brand
BARRON
Model
WLZ Series Low-profile
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents