2. Siemens
  3. DF-SX Dead Front Panel for the EN-SX Enclosure

Siemens DF-SX Dead Front Panel for the EN-SX Enclosure User manual

  • Hello! I've reviewed the installation instructions for the Siemens DF-SX Dead Front Panel. This document details the mounting process for this panel on the EN-SX enclosure, explaining how it protects electronic components and uses a screw and tab system for installation. I'm ready to answer your questions about it.
  • What is the purpose of the DF-SX?
    What screw is used for mounting?
    Where do the tabs of the DF-SX insert?
P/N 315-095991-5
Installation Instructions
Model DF-SX
Dead Front Panel for the EN-SX Enclosure
(For indoor use only in dry environments)
Figure 1
Installing the DF-SX
The Model DF-SX from Siemens Industry, Inc., is an
optional dead-front panel that is used on the EN-SX
enclosure to cover and protect the electronic compo-
nents.
MOUNTING
1. Insert the #6-32 x 5/16 screw provided in the tap hole
of the EN-SX enclosure, as shown in Figure 1.
Tighten the screw in place leaving a 1/4 -inch gap
between the head of the screw and the EN-SX
enclosure.
2. Insert the tabs of the DF-SX through the slots in
the top of the EN-SX enclosure (Refer to Figure
1). Let the deadfront cutout rest on the screw.
3. Tighten the screw in place. Make any adjustments
necessary to ensure the door of the enclosure
closes properly.
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
Siemens Building Technologies, Ltd.
Fire Safety & Security Products
2 Kenview Boulevard
Brampton, Ontario
L6T 5E4 Canada
EN-SX Enclosure
DF-SX Deadfront
Slots
Tabs
6-32 x 5/16 screw
Deadfront cutout
Tap hole
firealarmresources.com
/