2. Kasco
  3. Premium Nozzle

Kasco Premium Nozzle Installation guide

  • Hello! I've reviewed the Installation Instructions for the Kasco Premium Nozzles, specifically the Large J Series. This document provides a detailed guide on how to install the nozzles, including ensuring proper O-ring seating, using the provided tool, and securing the nozzle with the retaining clip. I am ready to help you with any questions about the installation process based on the document.
  • What should I do after removing the current nozzle?
    How to install premium nozzle?
    What to do if it's difficult to twist the nozzle?
    Do all nozzles require tool for installation?
    Why use retaining clip?
DOCUMENT # 884801
800 Deere Rd. Prescott, WI 54021 | 715.262.4488 | [email protected] | kascomarine.com
Large J Series Fountains
INSTALLATION INSTRUCTIONS
FOR PREMIUM NOZZLES
After removing the current nozzle and ensuring that the nozzle O-ring (A) is properly seated in its
groove, twist the nozzle clockwise (as viewed from the top) so that the anges in the nozzle lock into
place on the top of the pump chamber by hand. Twist until the nozzle anges can move no further and
are completely snug. Nozzles can be changed conveniently without removing the oat or using any
tools.
If it is dicult to twist the nozzle into place, dielectric grease
can be applied to the nozzle O-ring.
This kit includes a retaining clip which you can install to prevent
possible rotation of the nozzle when the fountain is running.
See instructions on the opposite side of this sheet.
For easy installation, use the provided tool. Snap it onto the
nozzle ridges as close to the base as possible. Leave the tool in
place for future nozzle changes.
A
Twist until
snug
Fern nozzle does not require tool. Simply twist and lock
into place.
DOCUMENT # 884801
800 Deere Rd. Prescott, WI 54021 | 715.262.4488 | [email protected] | kascomarine.com
RETAINING CLIP INSTALLATION INSTRUCTIONS
1
2
Snap!
3
Position the clip with
this side up if the
nozzle ring is metal.
Position the clip with
this side up if the
nozzle ring is plastic.
1. Insert the clip into one of the aligned gaps
in the nozzle and ring.
2. Twist the bottom of the clip over the ring.
3. Snap the clip into place.
/