2. Kasco
  3. Premium Nozzles
Premium Nozzles

Kasco Premium Nozzles User manual

  • Hello! I've reviewed the installation instructions for the Large J Series Premium Nozzles. This document details how to install these nozzles on your fountain, including the tool-free twist-and-lock mechanism and the use of the retaining clip. I am ready to answer any questions you might have about the nozzle installation.
  • What should I do if the nozzle is difficult to twist into place?
    Is any extra tool required to install the nozzle?
    How do I prevent the nozzle from rotating when the fountain is running?
DOCUMENT # 884801
800 Deere Rd. Prescott, WI 54021 | 715.262.4488 | [email protected] | kascomarine.com
Large J Series Fountains
INSTALLATION INSTRUCTIONS
FOR PREMIUM NOZZLES
After removing the current nozzle and ensuring that the nozzle O-ring (A) is properly seated in its
groove, twist the nozzle clockwise (as viewed from the top) so that the anges in the nozzle lock into
place on the top of the pump chamber by hand. Twist until the nozzle anges can move no further and
are completely snug. Nozzles can be changed conveniently without removing the oat or using any
tools.
If it is dicult to twist the nozzle into place, dielectric grease
can be applied to the nozzle O-ring.
After removing the current nozzle and ensuring that the nozzle O-ring (F) is properly seated in its groove, twist the nozzle clockwise
(as viewed from the top) so that the flanges in the nozzle lock into place on the top of the pump chamber by hand. Twist until the
nozzle flanges can move no further and are completely snug. Nozzles can be changed conveniently without removing the float or
using any tools.
Note: If it is difficult to twist the nozzle into place, dielectric grease (P) can be applied to the nozzle O-ring.
Installation Instructions for Premium Nozzles
Kasco Marine, Inc.
800 Deere Rd.
Prescott, WI 54021
PH (715) 262-4488
kascomarine.com
Document Number
884801
Rev 9-2020
Twist until
snug
A
Twist until
snug
This kit includes a retaining clip which you can install to prevent
possible rotation of the nozzle when the fountain is running.
See instructions on the opposite side of this sheet.
DOCUMENT # 884801
800 Deere Rd. Prescott, WI 54021 | 715.262.4488 | [email protected] | kascomarine.com
RETAINING CLIP INSTALLATION INSTRUCTIONS
1
2
Snap!
3
Position the clip with
this side up if the
nozzle ring is metal.
Position the clip with
this side up if the
nozzle ring is plastic.
1. Insert the clip into one of the aligned gaps
in the nozzle and ring.
2. Twist the bottom of the clip over the ring.
3. Snap the clip into place.
/