VersaStrider

ASSEMBLY INSTRUCTIONS

For Installation assistance or missing parts, please call CORE Health & FItness at 1(800) 503-1221Document # 620-8456 Rev. A

PAGE 1 OF 1

STEP 1:

Connect the heartrate grip cable coming out of the handle to the

corresponding recepticle on the frame. Install the user right side heartrate handle using

a 5mm allen key to secure four (4) pieces each of the M6 x 20mm socket head cap

screws and M6 hex lock nuts and (8) pieces of the M6 flat washer. Torque to 12 Ft-Lb

STEP 2: Using a crescent wrench and a 16mm socket, secure one (1) piece each of the

M10 x 70mm bolt and M10 hex lock nut and two (2) pieces of the M10 flat washer. Torque to

59 Ft-Lb (80 Nm). Be sure that a washer is included between the bolt and the frame as well

as the hex nut and the frame. Once the M10 x 70mm bolt is installed, tighten the M6 x 20mm

washers. Be careful not to overtighten as this could damage the shroud. Also ensure that

the fore heartrate grip grommet is installed onto the handle.

cap screws. Be careful not to overtighten as this could damage the

shroud. Repeat steps 3 + 4 for the user left outside and inside rear swing

link shrouds.

STEP 7: Install the user right side inner and outer handle pivot shrouds and secure

together using a 4mm allen key and four (4) pieces of M5 x 25mm socket head cap

screw. DO NOT FULLY TIGHTEN YET. Be sure to run the cable for the left and right arm

adjustment buttons above the support ribs in the outer handle pivot shroud. Install the

user right side pivot cap between the user right inner and outer handle pivot shrouds, then

tighten the four (4) M5 x 25mm socket head cap screws using a 4mm allen key. Repeat

step 7 for the user left side handle pivot shrouds.

STEP 8: Press the rear step assembly firmly down onto the frame so

the clips fully engage with the frame. Adjust the rear step assembly

leveling feet so the rear step assembly is level and then use the jam nuts

to lock the leveling feet adjusters in place.

Step 9: Fasten the back half of the console assembly to the mast

using the screws supplied with the console. Connect the appropriate

wires coming out of the mast to the correct console locations. Please