Tuffy 072-01 Installation guide

Hello! I've reviewed the Installation Instructions for the TUFFY Drawer Riser Kit 072. This document details how to properly install the kit in your vehicle, including marking and drilling locations, and fastening the drawer with the supplied hardware. I am ready to assist with any questions you might have.
What is included in the shipping package?

How many spacers are used to raise the drawer?

What should I do before drilling the holes?

Page 1 of 1 - 1/28/2008 – Rev122006

INSTALLATION INSTRUCTIONS

Drawer Riser Kit part #072

Please read and fill out the enclosed warranty registration card to activate your warranty.

Shipping Package

• (4) 5/16 X 2 ¼” bolts

• (4) 5/16” washers

• (2) 5/16” washers

Mounting Directions

1. Follow the mounting instructions included with the drawer but replace the drilling and fastening

portion of the instructions with these steps.

2. Place the drawer in the vehicle and mark the (4) drilling locations on the floor using the (4) holes in

the bottom of the drawer as a marking template. Make sure the drawer will open and close when

it is elevated 1” before marking.

Warning make sure there is nothing under the vehicle that will be damaged during drilling.

The gas tank is usually located in the rear of the vehicle.

3. Cut the carpet if necessary and drill out the (4) marked spots on the floor corresponding with the

holes in the bottom of the drawer.

4. Fasten down the drawer with the (4) 5/16 x 2 ¼” bolts, (4) 5/16 nuts, and (8) 5/16 washers using

(4) 1” spacers between with bottom of the drawer and the floor of the vehicle to raise the drawer

up.

5. Continue following the remaining installation instructions that came with the drawer.

Call (970) 564-1762 for Technical Support