2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Tuffy
  7. 059-01

Tuffy 059-01 Installation guide

  • I have reviewed the installation instructions for the TUFFY Drawer Riser Kit 059 & 068. This document provides step-by-step instructions on how to properly mount the drawer using the supplied hardware on a vehicle. The instructions also address drilling requirements. I'm ready to help with any questions you may have regarding the installation process.
  • What type of bolts are used to connect the drawer and riser brackets?
    Do I need to drill holes in a TJ vehicle to install this kit?
    What should I do if I need to drill holes?
INSTALLATION INSTRUCTIONS
Drawer Riser Kit part #059 & #068
Please read and fill out the enclosed warranty registration card to activate your warranty.
For office use only
❑ Shipping package
Checked by ______
Shipping Package
• (2) 8mm x 100mm bolts or 170mm
• (2) M8 lock nuts
• (2) 3/8x1” bolts
• (2) 5/16” washers
• (2) 3/8” washers
• (2) 3/8” locknuts
Mounting Directions
1. Place the drawer on the riser brackets, bolt
the drawer and the riser brackets together
using the (2)3/8 x 1” bolts supplied. Bolt
through the holes toward the opening -see
the figure to the right.
2. The long 8mm bolts supplied will go through
the drawer, and riser bracket, and through
the floor. In a TJ, there is no drilling
required, the 8mm bolt goes through the
floor and the holes in the side of the drawer
line up with the seat belt bracket holes. If
drilling is required, mark the appropriate
holes with the drawer in place and then
remove the drawer and drill. Warning make
sure there is nothing under the vehicle
that will be damaged during drilling.
3. Follow the directions given with your drawer
to complete the installation.
Call (970)564-1762 for technical assistance
/