A
C
E
A
D
B
F
A
B
Long tube (A x7pc)
Parts List
Assembly Instructions
Bend tube (B x4pc)
Round connector (E x4pc) Hexagonal connector (F x2pc) Thread (G x4pc) Peg (H x4pc) Cover (I x1pc)
Short tube (C x4pc) Flat connector (D x4pc)
Step 1: Insert the 4pcs long tube (A) into the round connector (E) to form a square shape, then insert the 4pcs short tube (C) into the round
connector (E) vertically. Fig 1.
Step 2: Connect the flat connector (D) and long tube (A) together, then insert into the short tube (C). Fig 2.
Step 5: Unfold the PVC cover and open the zipper. Assemble the PVC cover over the frame, then tie each belt on the cover to the frame. To fix the
frame to the ground firmly, tie one end of the thread to the loop of the cover and the other end to the peg (H). 4pcs pegs should be inserted on
the ground. Fig 5. To keep the greenhouse open, you can roll up the door and tie with the two belts. Fig 6.
Fig 1. Fig 2.
Fig 3.
Fig 5.
Fig 4.
Fig 6.
Step 3: Insert the bend tube (B) into hexagonal connector (F), and connect them together with a long tube (A). Fig 3.
Step 4: Insert the 4pcs bend tube (B) into the flat connector (D) from step 2. Fig 4.
/
