Inoxia SpeedTiles ID912-3 Installation guide

HOW TO INSTALL SPEEDTILES METAL MOSAICS :

1 Please ensure that the wall where you are installing the SpeedTiIes is CLEAN and SMOOTH.

2 STICKING TIP: Use a 500 ml to 750 ml bottle filled with water and add 1 to 2 tea spoon(s) of mild dishwashing liquid.

3 Then ﬁnd the highest countertop point and draw a level line from that point.

This line will serve as a guide to install the ﬁrst row of tiles.

4 Place the tile (pre-cut if needed) with the metal side facing the countertop and remove the Inoxia protection paper.

Spray a SMALL amount of soapy water mix on the adhesive and spread it with your hand over the whole surface.

Adding soapy water will allow you to perfectly adjust the tile on the wall by delaying the bonding time.

5 Once the tiles are in place, use a grout ﬂoat to press on the tiles to maximize the adhesion.

6 To obtain a professional ﬁnish, use a ﬁnishing silicone of the color of your choice.

BEFORE INSTALLING!

It is highly recommended to simulate the installation by placing the tiles ﬂat and

by ensuring the interlocking of the tiles.

PROPOSED TOOLS FOR INSTALLATION :

Mitre saw

Table saw

Large utility knife between, and/or on the mosaics

Gout ﬂoat

A B C D

Download PDF