Funktion: Gatewayen sender information - fra følgende regulatorer ......................................................................................................................
- til ..................................................................................................................................................................
Der er tilsluttet printer (ja/nej): ______ BUS terminering er åben (ja/nej): _____
Function: The gateway sends information - from the following controller ..........................................................................................................
- to ................................................................................................................................................................
Printer connection (yes/no): _____ BUS termination is open (yes/no): _____
Funktion: Gateway sendet Information - von folgenden Reglern ............................................................................................................................
- an .....................................................................................................................................................................
Drucker ist angeschlossen (ja/nein): ______ BUS Drahtverbindungen sind off en (ja/nein): _____
Fonction: envoie ses informations - en provenance des suivants .............................................................................................................................
- vers .............................................................................................................................................................................
Imprimante installée (oui/non): ______ Bouclage BUS ouvert (oui/non): _____
Función: El interface (gateway) envia información - desde los siguintes controles .....................................................................................
- a ............................................................................................................................................
Impresore instalada (Si/No): ______ Terminación BUS abierto (Si/No:) ______
SETTINGS
AKA 245
RI8JM153 08-2004
Indstillet af: Firma / Person / Dato
Set by: Firm / Person / Date
Eingestelt von: Firma / Person / Datum
Réglé par: Firm / Personne / Date
Ajustado por: Compañia / Persona / Fecha
------------------------------/---------------------------/---------------
AKA 245 indstillinger
AKA 245 Einstellungen
Réglages AKA 245
Ajustes AKA 245
Systemadresse
System address
Adresse système
Sistema dirección
Network : Address = ______:______
Software version 6.0x
Software Version 6.0x
Logiciel version 6.0x
Versión de software 6.0x
Time setting
Year Month Date Hour Minute Summer time
↓
Manual Auto
OFF OFF
ON ON
↓
Start Stop
Month: Month:
Date: Date:
Hour: Hour:
Confi guration
Code No.084B2268 Normal limit Extended limit Extended code Service code
Prog.ver 6.xx x= [1] [2] [40] [99]
Dansett time Dansett logoff Password “on/off ”
[60] [2] Delete password
Network : Address _ _ _ _ _ _:_ _ _ _ _ _
Side 2
Page 2
Seite 2
Página 2
RC-ET
2 Settings RI8JM153 © Danfoss 08/2004 AKA 245
Address & GWtype
Network address Change GWtype Boot gateway
↓↓-
Network: Address: PC Modem MSS
0 2 : ___
Communication setup - Router
Edit line
↓
Lower limit Upper limit Port No.
Address / Phone No./IP Address
0-123, 125 / Phone No.Network Network 1= DANBUSS
2= PC-/Modem/MSS Default = 0
Communication setup - RS 232 Port / - RS 232 Port
PC Modem and MSS
RS 232 Port speed Boot gateway Life time RS 232 port speed Boot gateway
Baud rate (9600) sec. Baud rate 9600
Boot gateway -
Communication setup - LON Port
LON Adr. range - - - Boot gateway
↓ -
LON Adr. Low LON Adr. High
/
