© 2013, AIS
Phone: 800.434.7400 Fax: 978.562.0811 Web: www.ais-inc.com
Catalog Product Date
All 01.30.13 1 of 2
Details
Wall Mounted Tack boards are installed by attaching clips directly to the wall, then attaching the tack board to the clips.
The tack board has pre-installed screws which the clips will hook onto.
Mounting Clip
Tack board
Step 1 - Placement
Place the tack board on the wall and softly tap the
locations where the pre-installed screws are on the back.
This will dent/mark the wall with locations you will need.
Note: Use a soft mallet to avoid damaging the tack board
or loosening the screws on the back.
Note: Use a hard surface (wood block, metal plate,
etc...) to protect the fabric from damage when tapping
the tack board.
IMPORTANT: The tack board will require 5/8” of space
above the fi nal placement location in order to be installed.
Please plan either to mount the tackboards fi rst or allow
for this space between the tack board and any overheads
in use.
Step 2 - Attach Brackets to the wall.
Using the marks from step 1, mount the brackets onto the
wall with the supplied clip screws. Align the clip so you
can see the mark through the “U” in the top of the clip.
Wall Mounted Tack boards (C-TACKINSTALLL) V2
Wall Mark
Clip Screws
Wall Mark
Allow for 5/8”
for overheads
5/8”
Pre-installed
screws
!
Marks left by
screw heads
Predrill and use appropriate light duty wall anchors.
© 2013, AIS
Phone: 800.434.7400 Fax: 978.562.0811 Web: www.ais-inc.com
Catalog Product Date
All 01.30.13 2 of 2
Details
Wall Mounted Tack boards are installed by attaching clips directly to the wall, then attaching the tack board to the clips.
The tack board has pre-installed screws which the clips will hook onto.
Wall Mounted Tack boards (C-TACKINSTALLL) V2
Step 3 - Install the Tack board
Using the marks from step 1, mount the brackets onto the
wall with the supplied clip screws. Align the clip so you
can see the mark through the “U” in the top of the clip.
Clip to screw detail
Tack
board
screw
Clip screws
(in wall with anchors)
Clip
Step 4 - Cord Groove
For tackboards with a tasklight groove, install the
pressure fi t sleeve onto the top of the tack board as
shown.
Tack board sits 3/16” off the wall
3/16”
/