© 2011, AIS
Phone: 800.434.7400 Fax: 978.562.0811 Web: www.ais-inc.com
Catalog Product Date
All 7/1/11 1 of 2
Details
Matrix Panel Mounted Overheads are installed using standard hanger frames on the Matrix frame. Attach the left and right
hanger frame brackets, install the center support (depending on scenario), and then hang the unit on the frame. Finish
the installation by installing the left and right hand locking brackets. Below are details of this installation.
Hanger Frame Bracket
(non-handed)
Locking Bracket
Step 1 - Install Hanger Frame Brackets
Install the Hanger Frame Brackets onto the ends of the
storage unit, using the supplied #10 x 2” Flat Phillips
Sheet Metal screws, using the pre-drilled holes as guides.
Center Support Bracket
~
Step 2 - Install Center Support
For units spanning two frames, a center support is
required. This piece should be placed in the seam
between the panels, so that the bracket is at the height
you want the bottom of the unit to be installed at.
Panel Mounted Overheads (C-COMXHINSTALL) V1
2”
#10 x 2” Flat Phillips
Sheet Metal screw
2”
#10 x 2” Flat Phillips
Sheet Metal screw
© 2011, AIS
Phone: 800.434.7400 Fax: 978.562.0811 Web: www.ais-inc.com
Catalog Product Date
All
Panel Mounted Overheads (C-COMXHINSTALL) V1
2 of 2
Step 3 - Hang the unit on the frame
When hanging the unit on the frame, pay attention to
the center support if applicable. If no center support is
needed, simply hang the unit.
Step 4 - Secure the Unit
Now that the unit is on the frame, install the locking
clamps on the bottom ends of the unit. If there is a center
support involved, you will also want to screw this into the
unit for added stability.
Locking Bracket (Left Hand) Locking Bracket (Right Hand)
Center Support
7/1/11
Screw - #10 x 3/4” Wood Flat Phillips
3/4”
IMPORTANT: Failure to install
anti-dislodge brackets could
cause injury.
/
