Pulse MLX402 User manual

Type
User manual
LINE LEVEL MIXER
Model: MLX402
1
CHANNEL
1
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
CHANNEL
2
CHANNEL
3
10
1010
10
10
10
10
10
10
10 0
0
5
5
0
0
0
0
0
0
0
0
CHANNEL
4
CH
A
CH
B
4 3 2 1
MASTER
MLX402
MLX402
POWER
POWER
12V DC
12VDC 200mA / 9V PP3
Batch: MM/YY
PEAK
PEAK
CHANNEL A
CHANNEL B
INPUTSOUTPUTS
LINE LEVEL MIXER
LINE LEVEL MIXER
Made in China
www.pulse-audio.co.uk
Rating Label
Box Label
Top Pan el
Rear Panel
Made in China
www.pulse-audio.co.uk
MLX402
LINE LEVEL MIXER
12VDC 200mA / 9V PP3
WHAT’s IN THE BOX
BATTERY INSTALLATION
OVERVIEW
IMPORTANT SAFETY INFORMATION
OPERATION
The mixer is designed to balance the input from 8 line inputs and adjust the outputs
volume to a recording device or amplier.
Please read these instructions carefully before use and retain for future reference.
With the power turned off and all level controls turned to minimum, connect up to four
line level inputs to the input jack sockets on each channel.
Connect the outputs to the amplier or the recording device using suitable cables.
Turn the power on and the LED will light.
Set the master volume to about half way on each channel and adjust each input level
as required.
When the balance is as required, adjust the master volume on each channel to suit
the input of the sound system or recording device.
The peak LEDs should ash briey on maximum level but not remain lit.
If the peak LED lights for longer, reduce the master volume.
When using electrical appliances basic safety precautions should always be followed.
Do not expose the units to moisture or dust and excessive temperatures.
The mixer can be powered either by a 9V PP3 type battery or a 12VDC 200mA PSU
(not supplied).
Mixer Unit
User Manual
Remove the two screws on the battery cover on the base of the mixer, and remove
the cover.
Connect the wiring connector to the battery observing the correct polarity.
Insert the battery into the compartment and replace the cover and screws.
MAINTENANCE
SPECIFICATIONS
Clean the outside casing with a soft cloth lightly moistened with mild soap and water.
Never use any abrasive or solvents.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
2
Inputs 8 x 6.3mm jack sockets
Input impedance 20kOhms
Output 2 x 6.3mm jack sockets
Output impedance 600 Ohms
Output level +4dB (+8dB max)
Battery 9V PP3
Power Supply (not included) 12VDC 200mA
Dimensions 150 x 108 x 65mm
Weight 637g
  • Page 1 1
  • Page 2 2

Pulse MLX402 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI