8 9
Using the Escape
To stand the Escape up, simply pull the tab on the front of the speaker all the way round so that the stand
fl ips out and then place on a stable surface.
iPhone/iPod dock
With mains power connected or batteries inserted:
1. Dock your iPhone/iPod onto the dock connector (4)
2. Press the Power button (1)
3. The LED will turn solid green
4. Press the play button on the iPhone/iPod
5. The sound will now play through the Escape
6. Volume can only be controlled using the Vol– (2) and Vol+ (3) buttons on the Escape
Charging your iPhone/iPod:
To enable the charge function, make sure the LED is green then dock your device and it will begin
charging. You can then press the power button on the Escape to go into standby mode.
Note: The iPhone/iPod will charge when docked on the Escape using mains power only.
Aux audio input
With the mains power connected or batteries inserted:
1. Plug one end of an aux cable (not included) into the aux-in (5) on the Escape
2. Plug the other end into your device
3. Press the Power button (1)
4. The LED will turn solid green
5. Press the play button on your device
6. Sound will play through the Escape
7. Volume can be controlled on both the Escape and the device you are using
PLEASE NOTE:
Your device will have an internal amplifi er and if it is playing digital fi les like MP3s it will also have an
integrated DAC (Digital Audio Converter). If you turn up the volume to 100%, your device will be sending
distorted signals to the Escape. To avoid this and to get the best sound quality from the speaker, we
recommend that you do not run your device any higher than 95% volume.