CMU043-A1 1 of 2
SIERRA WIRELESS AIRCARD 750
WIRELESS CARD INSTALLATION
FCC RF EXPOSURE INFORMATION
In August 1996 the Federal Communications Commission (FCC) of the United States with its action in
Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio
frequency (RF) electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are
consistent with the safety standard previously set by both U.S. and international standards bodies. The
design of this device complies with the FCC guidelines and these international standards.
** WARNING **
This device is approved for use only with the Sierra Wireless AirCard 750 transmitter. This device
has been tested and complies with the FCC RF exposure guidelines. Modifications not approved by the
manufacturer may result in violation of FCC regulations and may void the Users authority to operate the
equipment.
PC Card slots will not operate until a Sierra Wireless AirCard 750 transmitter is inserted
No other model of transmitter will activate the PC Card slots
Use only the supplied or an approved antenna. See below for detail. Unauthorised antennas,
modifications, or attachments could impair call quality, damage the phone, and will result in violation of
FCC regulations and will void the FCC ID.
When equipped with the Sierra Wireless AirCard 750, this product can only be used in Canada
and USA. This device has not been tested to comply with any other international standards bodies
The FCC ID shown on the CE8640 unit applies only when the Sierra Wireless AirCard 750 is
installed.
For more information about RF exposure, please visit the FCC web site at www.fcc.gov
For more information about the product certification, please contact [email protected]
CMU043-A1 2 of 2
Installation of
the Card
A software driver needs to be installed to activate the card.
** The driver needs to be installed before the card is
inserted
Contact your software integrator or Dap Technologies Technical
Support for more information. For more information refer to the
CE8640 Technical Guide at https://www.daptech.com
You also need an account with a wireless provider.
To install the card:
• Open the Expansion Bay as specified in previous section
“Use of PC Card”.
• Slide the AirCard 750 into either of the 2 slots
• Insert the antenna cable into the PC Card connector
• Install the antenna by screwing it on the antenna connector.
Do not over-tight
Replacement
antenna
Be sure to replace the antenna with the appropriate one.
Dap Technologies Part Number DCCE810
-
1
-
2
DAP Electronique Canada Limitee AirCard 750 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Sierra Wireless AirCard 710 Installation guide
-
-
-
-
-
-
-
Netgear 308U User guide
-
Sierra Wireless Wireless Modem Installation guide
-