PDU Mounting Kit
Select the mounting kit you are installing below. Use
the front side instructions to secure the brackets to the
PDU. Use the back side instructions to install the PDU
on the rack.
Slide Rail Mount
Button Mount
Side Panel Mount
Step 1 - Turn the PDU over, align the
top center hole, and screw the slide
rail to the PDU.
Screw
Step 2 - Push the sliding rail to
expose the second hole and
tighten the second screw.
Screw
Push
Slide
Step 3 - Repeat at the other
end of the PDU.
Step 1 - Using the center holes,
secure the mounting brackets to
both ends of the PDU with the
screws provided, as shown below.
Step 1 - Turn the PDU over and
screw the two round spacers to
the center at each end of the
PDU, as shown below.
Bracket Installation:
Part No. PAPE-1205-B00G
PDU Mounting Kit
Use the instructions below to secure the PDU to a rack
with the brackets installed on the front side of this
guide.
Slide Rail Mount
Button Mount
Side Panel Mount
Rack Installation:
Step 1 - Hold the PDU flush
against the side panel and secure
the brackets to the rack using two
screws at each end, as shown
below.
Step 1 - Have one person hold the PDU
and brackets flush against the rack, and
have a second person secure the top
bracket to the rack using two screws.
Rack
PDU
Screw
Driver
Step 2 – Slide the bottom bracket all the
way up on its rail, so that it’s in the
same position as the top bracket, and
then secure it to the rack. This will allow
the PDU to slide up and down in unison
on the rails once it’s secured.
Step 2 - Fit the round spacers into the
center of the mounting brackets to
secure the PDU to the rack.
Step 1 - Screw the mounting brackets to
the rack at a distance that equals the
round spacers on the PDU.
Part No. PAPE-1205-B00G
/