2. Trans-Dapt Performance
  3. 10241024

Trans-Dapt Performance 10241024 Operating instructions

  • Hello! I have analyzed the document for TRANS-DAPT Oil Filter Adapters models 1024 and 1324. This document provides instructions on converting to spin-on oil filter on specific Chevrolet V8 engines. The instructions emphasize the importance of using provided components and are very specific about torque when assembling the adapter and filter. I'm here to help you with your questions about the device and its installation.
  • What is the recommended oil filter to use with this adapter?
    What should I do with the pressure relief valve body?
    What do I need to be sure to remove from engine block before installing?
    What does this adapter do?
    What is important when tightening the Pal nut?
    What is important while installing oil filter?
DAPTDAPTDAPT
PERFORMANCE PRODUCTS
1. Remove the stock oil filter unit.
2. Remove the pressure relief valve body from the oil filter
cavity in the engine block. Be sure to remove any old
gasket material from the engine block.
3. Install the oil filter adapter body in the oil
filter cavity using the new 3-holed gasket and 1/4”-20 or
5/16”-18 screws .
4. Install the 3/4” threaded nipple into the adapter
body by threading the shorter end in first. Screw nipple in
until it bottoms out on the knurling.
5. Slide the new filter mounting flange
onto the nipple so it sets
flush against the adapter base installed in step 3. Apply a
small amount of removable threadlocker to the base of the
exposed nipple threads near the flange, and secure it in
place with the Pal nut , making certain PAL nut
comes in contact with the threadlocker.
6. Install oil filter.
We recommend that a #1156, Fram PH-8A (or
equivalent) be used with this adapter.
TRANS-DAPT
TRANS-DAPT
(furnished)
(furnished)
(with
DO NOT OVER
TIGHTEN THIS NUT!
Follow
manufacturer’s instructions carefully when installing any spin-on
element to this adapter.
Spin-on Oil Filter
and tighten
DO NOT OVER TIGHTEN THE OIL FILTER!
Over tightening the filter may stretch the nipple threads in
the aluminum adapter, causing leakage of oil.
machined filter
mounting surface facing outward)
(furnished)
‘68-69 SB & BB Chevrolet V8
(with 3/4-16" Nipple & 5/16”-18 Bolts)
Part 1324
#
‘56-67 SB & BB Chevrolet V8
(with 3/4-16" Nipple & 1/4”-20 Bolts)
Part 1024
#
[email protected]
Tel: 562-921-0404
NOT For Use on CHEVY II Vehicles
SPIN-ON OIL FILTER ADAPTER
1024-1324-instruction
/