2. Trans-Dapt Performance
  3. 13131313

Trans-Dapt Performance 13131313 Operating instructions

  • Hello! I've reviewed the TRANS-DAPT Oil Sandwich Adapter instruction sheet. This document provides step-by-step guidance on how to install the adapter for models 1313, 1320, 1322, 1350, 1358, and 1327. It details the process starting with removing the factory oil filter all the way to reinstalling the oil filter. I'm ready to answer any questions you have regarding this document or the installation process.
  • What should I do before installing the adapter?
    How do I install the sandwich adapter?
    What torque should I use when tightening the adapter?
    What is one thing I should be careful with during install?
DAPT
DAPTDAPTDAPT
PERFORMANCE PRODUCTS
OIL SANDWICH ADAPTER
INSTRUCTION SHEET
Part #’s: 1313, 1320, 1322,
1350, 1358 & 1327
BEFORE INSTALLING THIS TRANS-DAPT OIL SANDWICH ADAPTER, MEASURE CLEARANCE BEHIND
THE FACTORY FILTER. ALLOW FOR THICKNESS OF THE ADAPTER PLUS 3/4” FOR FILTER REMOVAL.
1. If filter O-ring is flush with rim of filter, rim may hit adapter first, not allowing a good seal. This may
occur with Japanese brands. Select another brand.
2. DO NOT OVERTIGHTEN cooler lines when connecting to the sandwich adapter.
1. Remove factory oil filter from engine.
2. Install sandwich adapter on factory filter landing with the appropriate O-ring installed in the adapter.
3. Screw sleeve nut on factory filter nipple until snug.
4. Position adapter in direction desired; tighten with wrench to about 25 foot pounds of torque.
5. Install oil cooler (not included) as per manufacturer’s instructions.
6. Reinstall factory oil filter.
CAUTION:
12438 Putnam Street Whittier, CA 90602 tel (562) 921-0404 fax (562) 921-7515
oil-sandwich-adapter-instructions.cdr
BEFORE INSTALLING THIS TRANS-DAPT OIL SANDWICH ADAPTER, MEASURE CLEARANCE BEHIND
THE FACTORY FILTER. ALLOW FOR THICKNESS OF THE ADAPTER PLUS 3/4” FOR FILTER REMOVAL.
1. If filter O-ring is flush with rim of filter, rim may hit adapter first, not allowing a good seal. This may
occur with Japanese brands. Select another brand.
2. DO NOT OVERTIGHTEN cooler lines when connecting to the sandwich adapter.
1. Remove factory oil filter from engine.
2. Install sandwich adapter on factory filter landing with the appropriate O-ring installed in the adapter.
3. Screw sleeve nut on factory filter nipple until snug.
4. Position adapter in direction desired; tighten with wrench to about 25 foot pounds of torque.
5. Install oil cooler (not included) as per manufacturer’s instructions.
6. Reinstall factory oil filter.
CAUTION:
oil-sandwich-adapter-instructions.cdr
12438 Putnam Street Whittier, CA 90602 tel (562) 921-0404 fax (562) 921-7515
DAPT
DAPTDAPTDAPT
PERFORMANCE PRODUCTS
OIL SANDWICH ADAPTER
INSTRUCTION SHEET
Part #’s: 1313, 1320, 1322,
1350, 1358 & 1327
/