Bradley S19-620 Installation guide

Bradley
Brand
Bradley
Model
S19-620
Category
Sanitary ware
Type
Installation guide
P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 1-800-BRADLEY FAX (262) 251-5817
http://www.bradleycorp.com
Installation
215-866 Rev. S; EN 06-515
© 2006 Bradley Corporation
Page 1 of 4 6/28/06
S19-620
Hand-Held Drench Hose and
Eye/Face Wash
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . .2
Installation Instructions . . . . . . . . . . . . . . . . . . .3
Assembly of Components . . . . . . . . . . . . . . . . .4
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
2
S19-620 Installation
6/28/06 Bradley Corporation • 215-866 Rev. S; EN 06-515
Pre-Installation Information
Operation
The eye/face body wash is activated when the handle on the valve is squeezed.
Components
Eye/Face and Body Spray: The quick-access emergency eye/face and body spray features a soft-
flow sprayhead for flooding large areas as well as the eyes only. The integral flow control assures
safe, steady flow under varying water supply conditions from 30-90 PSI. NOTE: The ANSI Z358.1
standard requires an uninterruptible supply of flushing fluid at a minimum 30 PSI flow pressure.
Valve: The chrome-plated brass valve with extended handle stays open until manually closed.
Recoiling Drench Hose: The 12’ (3655mm) self-coiling hose retracts for storage while allowing
instant extension in emergency situations. Hose is high-visible yellow. Burst strength is 250PSI.
Wall Bracket: Metal parts of the bracket are polished chrome plate.
WARNING
Read this installation manual completely to ensure proper installation, then file it
with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the
installer.
Separate parts from packaging and make sure all parts are accounted for before
discarding any packaging material. If any parts are missing, do not begin
installation until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation is
complete. Test the unit for leaks and adequate water flow. Main water supply to
the eyewash should be “ON” at all times. Provisions shall be made to prevent
unauthorized shutoff. Flushing fluid should be tepid per ANSI Z358.1.
The inspection and testing results of this equipment should be recorded weekly
to verify proper operation. This equipment should be inspected annually to
ensure compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should
be trained regarding the placement and proper operation of emergency
equipment per ANSI Z358.1.
For questions regarding the operation or installation of this product, visit
www.bradleycorp.com or call 1-800-BRADLEY.
Product warranties may also be found under ”Product Information” on our web
site at www.bradleycorp.com.
Installation
T
H
IS
S
ID
E
U
P
Packing List
P
.O
.
B
o
x
3
0
9
, M
e
n
o
m
o
n
e
e
F
a
lls
, W
I 5
3
0
5
1
R
T
E
S
T
T
H
I
S
U
N
I
T
E
A
C
H
W
E
E
K
Tes
t-operate valve
(s) each w
eek and sign below
.
R
eport any m
alfunctions im
m
ediately.
V
entil(e) w
öchentlich im
Testbetrieb prüfen, bestätig
t
durch U
nte
rschrift. Jegliche Störung sofort m
elden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date
Signed
Signed
Signed
D
I
E
S
E
S
G
E
R
Ä
T
1
S
T
W
Ö
C
H
E
N
T
L
I
C
H
Z
U
P
R
Ü
F
E
N
.
E
S
S
A
I
H
E
B
D
O
M
A
D
A
I
R
E
Test le fonctionnem
ent des valves chaque sem
aine et
signe en bas. S
'il y à quelque c
ho
se qui ne
va pas fait
un rapport im
m
édiatem
ent.
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-051
Installation Instructions
Supplies required for installation
• Three (3/8") wall anchors and three (3/8")
bolts
• Minimum 1/2" water supply pipe to connect
to 1/2" NPT connector on hand-held unit
• Pipe sealant or pipe dope
• Sign-mounting hardware
• Vacuum breaker as required by UPC, IPC
and/or local plumbing codes
Step 1: Install mounting bracket to
wall
NOTE: Make sure that, when mounted, the eye
wash unit will measure 33-45 inches from the
top of the sprayheads to the finished floor. For
usage as an eye/face wash, the top of the
sprayheads of the S19-630 must be 33–45
inches from where the user stands per
ANSI Z358.1. The unit must also be
placed a minimum of 6" away from
the nearest wall or obstruction.
1. Install three suitable wall anchors
for use with 3/8" bolts (supplied
by installer) into the wall at the
desired location (see Figure 1a
for eye wash dimensions and
Figure 1b for bracket
dimensions).
2. Bolt the mounting bracket to the
wall using three 3/8" bolts
(supplied by installer).
Step 2: Assemble eye/face
body wash unit
1. Assemble the component parts as
shown in Figure 2 on page 4.
• Be sure to apply pipe sealant to
all pipe joints.
Step 3: Connect water supply
1. Connect the water supply to the
unit (piping supplied by
installer).
2. Mount the safety sign to the wall using the sign-mounting hardware supplied by installer.
3. Open the water supply line. Test for leaks and adequate water flow.
3
Installation S19-620
Bradley Corporation • 215-866 Rev. S; EN 06-515 6/28/06
10-3/4"
(273mm)
11-1/4"
(285mm)
13-7/8"
(352mm)
33-45"
(838-1143mm)
TO FINISHED
FLOOR
Figure 1a
2"
(51mm)
2"
(51mm)
4"
(102mm)
2"
(51mm)
4-11/32"
(110mm)
27/32"
(21mm)
Figure 1b
Assembly of Components and Parts List
4
S19-620 Installation
6/28/06 Bradley Corporation • 215-866 Rev. S; EN 06-515
1 S27-265 1 Valve Assembly with Handle
1.1 269-661 1 Handle only
2 S70-094 1 Wall Bracket
3 153-337 1 Adapter
4 S05-064D 1 EFW Assembly
4.1 S05-091P 1 Yoke Assembly
4.2 S05-135 2 Sprayhead Assembly
4.3 S53-063 2 Dust Cover Assembly
5 141-008 1 Hanger
6 110-212 1 Nut, Lock
7 113-635 1 Nipple
8 169-078 1 Coupling
9 269-053 1 Hose, 12’
10 114-051 1 Safety Sign
11 204-421 1 Emergency Tag
Item Part No. Qty Description
Item Part No. Qty Description
4.1
3
2
8
11
1.1
7
6
5
9
4.2
4.3
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-051
10
P.O. Box 309, Menomonee Falls, WI 53051
R
TEST THIS UNIT EACH WEEK
Test-operate valve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE
Test le fonctionnement des valves chaque semaine et
signe en bas. S'il y à quelque chose qui ne va pas fait
un rapport immédiatement.
4
1
Figure 2
NOTE: Items 1–8 come preassembled.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Bradley S19-620 Installation guide

Bradley
Brand
Bradley
Model
S19-620
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents