2. PREMIER 1
  3. 530024
530024

PREMIER 1 530024 User manual

  • Hello! I've reviewed the installation manual for the PREMIER Horizontal Drip-Catch Nipples. This document provides instructions for installing these units on either a bucket or a PVC pipe, noting the importance of drilling the correct hole size and not overtightening during installation. I'm ready to assist with any questions you may have about setting up your new product.
  • What size drill bit should I use?
    Where should I drill the hole on a bucket?
    Is it possible to overtighten the drinker?
Installation Instructions
Using a square or round bucket,
drill a 3/8" hole with center
3/4" from bucket bottom.
STEP
1
BUCKET(S)
DRILL
with 3/8" bit
HORIZONTAL
DRIP-CATCH NIPPLES
PVC PIPE
STEP
1
Using a PVC pipe, drill a
3/8" hole.
STEP
2
Thread the drinker into the hole,
do not overtighten.
–OR– STEP
2
Thread the drinker into the hole
until taut, do not overtighten
(this can oversize the hole).
NIPPLES WITH A BUCKET…
NIPPLES WITH PVC PIPE…
WHAT YOU WILL NEED
/