2. Cetacea Sound
  3. Orbiter Commander

Cetacea Sound Orbiter Commander, Orbiter, V1, Orbiter, V2 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Cetacea Sound Orbiter Commander Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
© 2015 Cetacea Sound Corp. All rights reserved.
Orbiter™ is a trademark of Cetacea Sound Corp.
(800) 556-1922 [email protected] www.cetaceasound.com
All audio products are proudly made in the U.S.A. (8/15) 201204-007
Orbiter Pairing Instructions
1) Make sure the Orbiter pendant transmitter has been properly charged and
is NOT connected to the charger.
2) Both the transmitter and receiver must be ON in order to pair.
NOTE: We recommend that the receiver is not plugged into
the speaker while pairing.
3) Straighten the end of a
medium paper clip.
4) Insert the end of the paper clip approximately ¹/
16
" (1.5 mm) into the pairing
hole on the receiver. Use a light press when inserting the paper clip not to
damage the hardware. The receiver amber light will begin to flash indicating
that it’s in pairing mode.
Orbiter
WIRELESS PENDANT MICROPHONE
TRANSMITTER
PAIRING HOLE
15V DC
PWR
VAR
LINE
1
2
3
ORBITER
INPUTS
OUTPUTS
15V DC
PWR
VAR
LINE
1
2
3
ORBITER
EXT. ANT.
INPUTS
OUTPUTS
PAIRING HOLE
Pairing Instructions
LINE OUT
DC OUT
PAIR
LINE OUT
PAIR
5) Insert the end of the paper clip approximately ½" (1.3 cm) into the pairing hole
on the transmitter. Use a light press when inserting the paper clip not to damage
the hardware. Successful pairing will result in a solid amber light on the receiver.
6) Receiver pairing mode lasts only a short time. If unsuccessful, repeat steps 4 and 5.
ORBITER DESKTOP RECEIVER ORBITER CEILING RECEIVER
PAIRING HOLE
/