Cetacea Sound Orbiter, V1 Operating instructions

Cetacea Sound
Brand
Cetacea Sound
Model
Orbiter, V1
Type
Operating instructions

This manual is also suitable for

© 2015 Cetacea Sound Corp. All rights reserved.
Orbiter™ is a trademark of Cetacea Sound Corp.
(800) 556-1922 [email protected] www.cetaceasound.com
All audio products are proudly made in the U.S.A. (8/15) 201204-007
Orbiter Pairing Instructions
1) Make sure the Orbiter pendant transmitter has been properly charged and
is NOT connected to the charger.
2) Both the transmitter and receiver must be ON in order to pair.
NOTE: We recommend that the receiver is not plugged into
the speaker while pairing.
3) Straighten the end of a
medium paper clip.
4) Insert the end of the paper clip approximately ¹/
16
" (1.5 mm) into the pairing
hole on the receiver. Use a light press when inserting the paper clip not to
damage the hardware. The receiver amber light will begin to flash indicating
that it’s in pairing mode.
Orbiter
WIRELESS PENDANT MICROPHONE
TRANSMITTER
PAIRING HOLE
15V DC
PWR
VAR
LINE
1
2
3
ORBITER
INPUTS
OUTPUTS
15V DC
PWR
VAR
LINE
1
2
3
ORBITER
EXT. ANT.
INPUTS
OUTPUTS
PAIRING HOLE
Pairing Instructions
LINE OUT
DC OUT
PAIR
LINE OUT
PAIR
5) Insert the end of the paper clip approximately ½" (1.3 cm) into the pairing hole
on the transmitter. Use a light press when inserting the paper clip not to damage
the hardware. Successful pairing will result in a solid amber light on the receiver.
6) Receiver pairing mode lasts only a short time. If unsuccessful, repeat steps 4 and 5.
ORBITER DESKTOP RECEIVER ORBITER CEILING RECEIVER
PAIRING HOLE
  • Page 1 1

Cetacea Sound Orbiter, V1 Operating instructions

Cetacea Sound
Brand
Cetacea Sound
Model
Orbiter, V1
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents