FunTrek 130 Quick Guide
1. Appearance
FunTrek 130
HO L UX
Button Functions
Name Function
Touch Screen
The device uses touch screen controls
Right /
Power Button
When device is on, press right button to open
shortcut menu
When device is off, hold down right button for 3
seconds to power on
When device is on, hold down right button for 3
seconds to power off
Left Button
When device is on, press the left button to
change the Main Menu, Trip Computer and
Navigation screens
LED Status
Light
Charging: Blinks red
Full charged: Constant red light; red light
turns off when USB cable is disconnected
When powering up, the LED will light for 1
second and the display will turn on
2. Screen Operations
3. Mount Installation
(1) Please combine the brackets and make sure that the two ends are clipped together.
(2) Screw holder firmly to the bracket.
(3) Open the other end of the bracket and clip it to the handlebar. Place rubber padding underneath the holder.
Adjust the thickness of the rubber padding to match the actual thickness of the handlebar then tighten screws to
install the bicycle mount firmly.
(4) Insert GPS into holder. When it click into place, tighten the screw on the back of the holder.
(5) To remove the GPS, loosen the screw on the back of the holder, press lightly on the pressure tab protruding
from the bottom of the holder then remove GPS.
(1) (2) (3) (4) (5)
Touch
Screen
Left
Button
LED Status
Light
Right/
Power
Button
Left
Right
Right
Left
Right
4.Status Bar and Icons
Satellite Info
Icon Description
/
Satellite info
Strong signal/no signal
Cold start
Time
Icon Description
Time information including clock, date
and day of the
week
Alarm setup shortcut; indicates alarm
is on
Indicates alarm is off
Charge Info
Icon
Description
Charge full
Battery low, 1/3 remaining
Battery low
Memory Card
Icon
Description
Tracks and waypoints are stored in
SD card
Tracks and waypoints stored in
internal memory
Compass
Icon
Description
Compass is calibrated
Compass requires calibration
Alarm
Icon
Description
Indicates alarm is on
Indicates alarm is off
Backlight
Icon
Description
Backlight is on
Backlight is off
Screen Lock
Icon
Description
Screen is locked
Screen is not locked
Track Log
Icon
Description
Recording track
Track recording paused
Basic Button Functions
Icon Description
Create new file
Display 3 Trip Computer pages
Pause (used by Alarm and Track Log)
Trip Computer setup
Confirm
Icon Description
Back
Display 6 Trip Computer pages
Start (used by Alarm and Track Log)
Next Page
Previous Page
※ Note: Please use the bundled USB cable to connect the device to the PC/Notebook and access stored data.
The bundled charger should be used for charging.
※ New product firmware updates and maps will be available on our company website.
/