Emsco 2097HD Operating instructions

Girard, PA 16417

www.emscogroup.com

3 EASY STEPS

Create curves, corners and straight runs by simply snapping the fencing

pieces together. Interlocking sections make continuous lengths.

Continue fencing run.

As you go, snap French Ivy-Style fencing pieces together with convenient

interlocking system.

Lay out fencing pieces along

the area where you want to install. Be

sure the fencing pieces are touching. You

may want to snap them together as you

proceed. See illustrations below for

instructions on how to connect pieces

for your desired eect.

In order to make a curved section of a run,

or to make a corner where the faces of two

connection pieces move toward each other,

you must open the slots on the female part

(Fig. 1) of the hinge. You can do this with a

utility knife or any other sharp knife. Remove

the thin section of the piece. This is easily seen

when viewing the piece from the back. When

you are done, the hinge should look like Fig. 2.

Do this for both top and bottom hinges on the piece.

Fig. 1

Push pointed anchor posts

into ground. If ground is too hard,

soften it with water. If necessary, make

starter holes with screwdriver.

Fig. 2

This manual is also suitable for

Download PDF