Page is loading ...
Girard, PA 16417
www.emscogroup.com
3 EASY STEPS
Create accent corners and straight runs by simply tapping stakes through
interlocking pieces to secure. Interlocking sections make continuous lengths.
Continue fencing run. As you go, t Dackers Edging pieces
together with convenient interlocking system. The pieces are completely
exible, so they are easy to use in straight sections, circles and sweeping
curves. When run is complete, secure border pieces by gently hammering
stakes to ground level.
3
Unsnap steel rod stakes
from back of edging and
insert up through holes in bottom
of edging. Lay out edging along
the area where you want to install.
Be sure edging pieces are
touching. Tap stakes down evenly,
leaving 1" from the elbow of the stake to the ground. If ground is too
hard, soften it with water. DO NOT HAMMER IN COMPLETELY. This will
allow you to add more edging pieces by pivoting into position and
connecting to rst piece.
1
Customize your edging
t by cutting between any two
segments. When cutting edging,
have front of section facing
you. Remove desired number
of segments from the right side
of edging. At this point you can
move steel rod to outermost
holes of adjusted segment.
2
Push stakes up
through border.
After trimming
edging, move
stake to new
outermost hole.
Trim line
Hammer stakes to ground level
to secure permanently.
/
