Astria Fireplaces Tuscan Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
Tuscan
Category
Fireplaces
Type
Instruction Sheet

This manual is also suitable for

1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
REPLACEMENT SUPPORT KITS
INSTALLATION INSTRUCTIONS FOR INSTALLING REPLACEMENT FIREPLACE SUPPORTS. FOR USE WITH WOOD-
BURNING FIREPLACE MODELS WRE3036/3042, WRT3036/3042, WCT3036/3042, WRT2036, WCT2036, MHWB36CB,
MHWB36R, TUSCAN36/42, CRAFTSMAN36/42, BLACKSTONE36 AND COLUMBUS36/42
P/N 900805-00
REV. A, 11/2016
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS
4 ea. Supports, Fireplace - 36” model kit only
5 ea. Supports, Fireplace - 42” model kit only
24 ea. Screw - 36” model kit only
30 ea. Screw - 42” model kit only
1 ea. Instruction Sheet
TOOLS/SUPPLIES NEEDED
Marker, Pencil or Chalk
1/4” Drill Bit
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
INSTALLATION INSTRUCTIONS
1. Remove all the bricks from the fireplace and place them face up on
the ground away from the fireplace.
2. Gently lay the fireplace on it’s back so you can see the bottom fireplace
supports (Figure 1), this may require two people.
3. Take the new fireplace support (Figure 2) and lay it on top of the ones
on the bottom of the fireplace (Figure 3). Make sure the edges are
lined up, mark the six holes with a marker, pencil or chalk.
4. Drill the holes with a 1/4” drill bit, once you have drilled all six holes
attach the new support to the bottom of the fireplace with the screws
that are provided (Figure 4).
5. Once you have completed attaching all the new supports (4 for 36” and
5 for 42”) to your fireplace stand the unit up and reinstall the bricks.
Figure 1 - Lay Fireplace on its Back
Figure 2 - Fireplace Support
Figure 3 - Place New Supports Over Existing Supports
Figure 4 - Install New Supports
Replacement Support Kits
Cat. No. Model Description
F3192 FP-SPRT-WB36 Support Kit, Fireplace 36”
F3193 FP-SPRT-WB42 Support Kit, Fireplace 42”
2
Printed in U.S.A. © 2016 Innovative Hearth Products
P/N 900805-00 REV. A 11/2016 1508 Elm Hill Pike, suite 108 • Nashville, TN 37210
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifications, and prices, and also to discontinue colors, styles, and products.
Consult your local distributor for fireplace code information.
  • Page 1 1
  • Page 2 2

Astria Fireplaces Tuscan Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
Tuscan
Category
Fireplaces
Type
Instruction Sheet
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents