2. Steelcase
  3. Series 9000 E.I.P. Keyboard Shelf – Model # 99953

Steelcase Series 9000 E.I.P. Keyboard Shelf – Model # 99953, Series 9000 E.I.P. Keyboard Shelf - Model # 99953 Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Steelcase Series 9000 E.I.P. Keyboard Shelf – Model # 99953 Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-800-227-2960
Tools
Assembly Directions Printed In U.S.A.
REV
93-9501045 -
Page 1 of 2
5/32” DRILL BIT
KEYBOARD SHELF
Series 9000®
E.I.P. Keyboard Shelf Model #99953
NOTE: If shelf height needs adjustment see next page before installing. Do not assemble to units with lock rails.
Assembly Directions
93-9501045 REV - Page
2 of 2
1. Turn work surface or unit upside down and locate shelf .
2. Using holes “C” as a template, mark mounting holes on
work surface. Remove shelf and drill (4) 5/32” holes.
3. Using holes “C” align washers between work surface and
keyboard shelf. Fasten shelf to top.
NOTE: Dimension “X” may vary depending
on desired location in available kneespace.
Minimum kneespace required is 27-5/8”.
2 FLAT WASHERS REQ’D EACH SIDE
(9000 LINE WORKSURFACE ONLY)
X
C
#12 x 7/8”
SCREW (4 REQ’D)
LOCATE 1/2” FROM
FRONT EDGE OF
WORKSURFACE
Keyboard Shelf Height Adjustment
1. Extend shelf. Locate suspension mounting screws and remove.
2. Pivot shelf to desired position and install screws.
3. Repeat procedure for mounting screws. Securely tighten all screws.
ALIGN HOLE IN SUSPENSION
WITH SCREW AND REMOVE
SUSPENSION
MOUNTING SCREWS
SUSPENSION
MOUNTING SCREWS
SUPPORT
SHELF
/