Page is loading ...
Page 1 of 4
939502068 Rev C
FrameOne™ - Return Installation
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
© 2010 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Page 2 of 4
939502068 Rev C
1. Turn the worksurface over onto a
clean, soft surface like carpet.
2a.
2b. Snap leg bracket covers onto leg
brackets, between leg and worksurface.
Use pilot holes to locate and install
the Leg Trim Assembly with the screws
provided.
1TIP: Use a shim to elevate
one edge of the worksurface.
This will allow a finger hold
when assembly is ready to
turn upright.
2a
PILOT HOLES
LEG TRIM ASSEMBLY
LEG BRACKET COVERS
2b
Page 3 of 4
939502068 Rev C
3. Use pilot holes to locate and install
the Strengthening Channel.
NOTE: 36” wide units will use (2) of
the Strengthening Channels.
4. Use pilot holes to locate and install
the (2) Tie Plates with the screws
provided.
PILOT HOLES
3
4
PILOT HOLES
for
TIE PLATES
STRENGTHENING CHANNEL
Page 4 of 4
939502068 Rev C
5. Position the return at desired
location with the bench, then align the
worksurface edges flush.
6. Secure the return with the screws
provided (no pilot holes are provided
on the underside of the the bench
worksurface).
7. Adjust leveling glides as needed.
5
Return shown flush here,
but it could be located
anywhere along the bench.
6
77
/
