GenTran 6365V Operating instructions

Brand
GenTran
Model
6365V
Type
Operating instructions

This manual is also suitable for

© 2007. Gen-Tran Corporation. PowerStay and Gen/Tran are registered trademarks of Gen-Tran Corporation. 1-23-07
Power Inlet Boxes
For Models 530V, 1420V, 1430V, 6365V
INSTALLATION INSTRUCTIONS
Warning: Installation of this Power Inlet Box and related wiring must be done by a qualified electrician in compliance with all applicable
electrical codes. NOTE: THIS POWER INLET BOX SHOULD BE INSTALLED WITH AN APPROVED TRANSFER SWITCH.
Installing the Power Inlet Box:
These instructions describe how to install a remotely located
power inlet box for supplying power to a Transfer Switch.
1. Remove the front cover by loosening the screw on the lower front.
2. Using the three mounting holes in the back of the housing, secure the housing to
the structure. Sealant should be used around the anchoring screws to keep water
from entering the box at these mounting holes.
3. Using approved wiring methods, install the wiring through one of the knockouts
provided in the housing. Be sure to seal around the hole in the building where the
conduit enters through the wall.
4. Extend wiring inside the PIB approx. 6” from the point of entrance. Attach the
green or bare ground wire to the green lead provided in the PIB with a wirenut (provided by installer).
5. Strip the incoming leads approx. 5/8” and insert into the terminals on the male power inlet. Insert the white lead (neutral) into the nickel
plated screw terminal or white marking on the inlet. “Hot” leads are inserted into terminals noted by black or red markings or “X”
and “Y”.
6. Carefully fold the wires into the enclosure and reattach the cover to the housing. Installation is complete.
__________________________________________________________________________________________________________
TO COMPLETE YOUR BACKUP POWER INSTALLATION…
You may purchase Transfer Switches, Power Cords and Plugs or Connectors on our website at www.gen-tran.com or by calling toll free
1-888-GEN-TRAN.
Note: Male plugs connect to generator, and female receptacles connect to Power Inlet Box or Transfer Switch. Check your generator
receptacle for exact receptacle configuration to avoid ordering the wrong part.
Alpharetta, GA 30009
Toll Free: 1-888-GEN-TRAN
Fax: 770-552-7756
www.gen-tran.com
PN 51164 Rev A
  • Page 1 1

GenTran 6365V Operating instructions

Brand
GenTran
Model
6365V
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents