Rugged Ridge 11652.01 Installation guide

Brand
Rugged Ridge
Model
11652.01
Type
Installation guide
Page 1
Flush Mount Tail Light, JL
Part # 11652.01
4.
6.
1. 2. 3.
5. 7. 8.
9.
Components and Hardware:
Components and Hardware: Tools for Installation:
1. Left Tail Light Mount .......................................................................(1)
2. Right Tail Light Mount.....................................................................(1)
3. Wire Harness ...................................................................................(2)
4. Oval Light.........................................................................................(2)
5. Oval Light Grommet ........................................................................(2)
6. Round Light .....................................................................................(2)
7. Round Light Grommet ....................................................................(2)
8. Reector Tape .................................................................................(4)
9. No 4 Phillips Screw .........................................................................(6)
10. Adhesive Promoter .........................................................................(1)
•10mm Socket
•T40 Torx Socket
•No 2 Phillips Head Screw Driver
•Isopropyl Alcohol
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com REV_0.0 11/17/2022
Page 2
Part # 11652.01
Flush Mount Tail Light, JL
1. Lift plastic cover in cargo area to gain access to tail
light mounting bolt.
2. Using either a 10mm or T40 torx socket, unscrew OE
mounting bolt and carefully pull tail light away from ve-
hicle. Unplug tail light by sliding red tab rst. Then press
down on gray tab and gently pull plug from light.
3. Remove OE mounting bracket by unscrewing Phillips
head screws.
1
2
REV_0.0 11/17/2022
Page 3
Part # 11652.01
Flush Mount Tail Light, JL
4. Using supplied No 4. Phillips screws(#9), attach tail
light mount(1&2) to OE mounting bracket.
5. Affix the oval light grommet(#5) into tail light mount.
Press the oval light(#4) into the oval light grommet.
6. Affix the round light grommet(#7) into tail light
mount. Press the round light(#6) into the round light
grommet.
REV_0.0 11/17/2022
Part # 11652.01
Flush Mount Tail Light, JL
7. Connect the oval and round lights to the supplied wire
harness(#3). Wires on the harness and lights are color
coded. Connect each wire from the light to the color
matched wire on the harness.
8. Connect wire harness into factory wire harness. Reus-
ing the OE tail light mounting bolt, attach ush style light
to vehicle.
9. Note: The reective tape needs to be visible from both
the side and the rear of the vehicle.
To attach Reflective Tape)#8), first clean the surface of
where you want to attach the tape using isopropyl alcohol.
Then apply adhesive promotor(#10) to the surface and let
it sit for 2 minutes. Remove protective film on the
reflective tape and then attach tape to prepared surface.
Page 4 REV_0.0 11/17/2022
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Rugged Ridge 11652.01 Installation guide

Brand
Rugged Ridge
Model
11652.01
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents