2. Rugged Ridge
  3. 11025.20

Rugged Ridge 11025.20, 11025.14, 11025.18, 11025.22, Square Stubby Trail Mirror Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge Quick Release Mirrors, specifically models 11025.12, 11025.13, 11025.14, 11025.18, 11025.20 and 11025.22. The document details the components and provides step-by-step guidance for installation on both JK and TJ Jeep models. I understand the mirror is adjustable and that it is recommended to use the mirrors without doors on TJ models. I'm ready to answer your questions about the product.
  • What tools are needed to install the mirror on JK models?
    What is the recommendation for using these mirrors on TJs?
    What are the included components of the quick release mirror kit?
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Quick Release Mirror
Page 1/3
Part #11025.12
11025.13
11025.14
11025.18
11025.20
11025.22
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
1
2
3
4
5
6
1. Mounting Bracket
2. Thumb Screw
3. Bushing
4. M8 Bolt
5. Arm
6. Mirror
Components
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Quick Release Mirror
Page 2/3
2. Using supplied hardware, install Mounting
Bracket with welded nut facing down.
1. For JK (07-17): Using T40, Torx Wrench, remove
two upper windshield bracket bolts.
For TJ (96-06): Using T40 Torx Wrench, remove two
ush mount torx head bolts just in front of door
hinge.
3. Attach Arm to Bushing. Using Thumb Screw,
loosely install Bushing and Arm into Mounting
Bracket.
JK TJ
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Quick Release Mirror
Page 3/3
5. When doors are reinstalled remove Arm from
bracket. Place Bushings back into Mounting
Bracket and tighten Thumb Screw.
4. Attach Mirror to at side of MArm using Mirror’s
hardware. Tighten screws on the back of the Mirror.
Mirror should be tighten but able to be adjusted if
needed.
For TJs (97-06), it is recommended to use
quick release mirrors without doors on
vehicle.
WARNING
!
/