Following table shows set-points level
Description LED OFF LED ON
GUIDE TO SELECTING FUNCTIONS
Temperature selection pushbutton is used to set
desired temperature level, from warmest through
lower to coldest . Pressing pushbutton setpoint will
change cyclically.
Cooling off / stand-by function
This function turns off the refrigerator and freezer
compartments. To put the appliance in this state press and
hold temperature selection pushbutton for 3 seconds.
When the product is in this mode the light operates
normally,but all other functions are disabled and control
panel shows no indication.
Appliance comes back to normal operation, control panel
displays previously chosen set-point after press
temperature selection pushbutton again.
Notes:
- In case of power failure, appliance goes back to normal
operation and previously chosen setpoint is restored.
- Remember that this operation does not disconnect the
appliance from the power supply.
- When the appliance has to be left for a longer period
with fridge door open to avoid odour, power cord must
be unplugged from the power supply.
ECO GREEN function (depending on the model)
This function gives best food preservation performance
with the smallest energy consumption possible (around 5-
10% less in comparison with the normal settings) if there
is lower amount of food to be preserved in the appliance.
The best food preservation conditions when ECO
function is activated are in the ECO compartments:
- 2 "eco green" shelves in the fridge (with green frames)
- 1 "eco green" basket in freezer compartment.
ABNORMAL APPLIANCE OPERATION
When the product is plugged in to the mains, during first 10
minutes of its performance, possible temperature sensor
failure will be displayed according to following table:
Description LED OFF LED Flashing
The appliance will work preserving the food stored, but it
is necessary to contact after-sales service and provide
alarm code.
DEFROSTING THE FREEZER
COMPARTMENT
The freezer should be
defrosted once or twice a year
or when excessive frost is
present (3 mm thickness).
The formation of frost is
normal.
The amount and rate at which
frost accumulates depends on
room conditions and how often the door is open.
To defrost the unit, switch off the freezer compartment or
the whole appliance, depending on the model, and
remove all food products.
Leave the freezer door open to allow the frost to melt.
For appliances in figure only pull out the defrost water
drain and place a container under the drain.
When the operation is completed, put back the defrost
water drain.
Clean the inside of the freezer. Rinse and dry thoroughly.
Switch the freezer compartment, or the whole appliance,
back on and store the food inside.
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase is
in progress. The defrost water is automatically run into a
drain hole and collected in a container, where it
evaporates.
REPLACING THE LIGHT BULB
Always disconnect the
refrigerator from the power
supply before replacing any
light bulb.
If the inside light is not working, it is necessary to:
1. Remove the light cover: put the fingers into the side
ventilation holes (1), stretch the cover gently and
move it upwards.
2. Check the bulb. If necessary unscrew the broken bulb
and replace it with the new one (use maximum 15W
bulb).
3. Put on the light cover.
Do not leave the bulb uncovered.
5019 637 01085 Printed in Poland 04/10
Refrigerator sensor failure
Freezer sensor failure
Refrigerator & freezer sensor failure
high temperature
low temperature
extra low temperature
ROBGRUSHSKCZPLFINDKNSGRIPENLFGBD
PRODUCT SHEET
GB
