Access HD DTA1080D Quick start guide

Type
Quick start guide

This manual is also suitable for

Rev. June 5, 2008 Access HD® is exclusively distributed by GXi International, LLC Page 1 of 2
CONNECTING YOUR DIGITAL CONVERTER BOX
Connect the antenna to the ANT IN jack on the back of the converter box.
Using the supplied RF Coax Cable, connect the RF OUT jack on the back of
the converter box to the ANTENNA IN jack on the back of your TV.
(NOTE: You may also connect converter box to TV with optional RCA Audio/Video Cables)
Connect the small end of the Power Supply to the DC IN jack on the back of the
converter box; and plug the other end into a power outlet or surge protector.
Turn ON the converter box and TV.
Set your TV to Channel 3 to match the default CH3 setting of the converter box.
Quick Start Guide
1
1
2
3
2
3
4
5
Rev. June 5, 2008 Access HD® is exclusively distributed by GXi International, LLC Page 2 of 2
Please verify the following:
The batteries are correctly installed in the
Access HD remote control.
The TV is ON and the digital converter box
is powered ON (Green LED/Light on front)
The converter box and your TV are both
set to Channel 3 (or both 4).
Initial Setup Menu
2. Set the Time Zone:
Press to select Time Setup
Press to set your Time
Zone (Pacific, Alaska, Hawaii,
Eastern, Central, Mountain)
1. Set the Menu Language:
Press to set your Language
(English, Spanish, French)
3. Auto Program Channels:
Press to select Auto
Channel Searching
Press to begin
searching for channels
It will Perform a Fast Scan (1-2 minutes)
It will then Perform a Digital Scan (4-6 min)
Please be patient, as this complete
process takes from 5 to 8 minutes
DO NOT INTERRUPT THE PROCESS
Once the Auto Channel Searching is
finished, it will automatically exit and
display the first channel found
  • Page 1 1
  • Page 2 2

Access HD DTA1080D Quick start guide

Type
Quick start guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI